Hobbyking 1610 Brushless Outrunner 3400KV

• Overall
• Quality
• Value

Customer Rated

Nov 26, 2012

I'm using 6 of them with 3"x3" props (2s) on a seaplane.
On the water the starting behaviour leaves room for improvement.
Starting the plane by hand is no problem.

Four motors are starting willingly, two need some time to find the right direction.
Once running they ear pretty good.
If the props are fixed with stronger rubber bands starting gets better but not really good.

• Overall
• Quality
• Value

Customer Rated

Nov 17, 2012

The wires are so brittle that i kept breaking them just clamping thim in my soldering jig! beautiful little motor though!

• Overall
• Quality
• Value

Customer Rated

Mar 24, 2012

Hi All!
I bought 2 of them for the Bonsai EPP WIng. Great little Motor! Perform well w/ a 5030 Airscrew in a 2S Setup w/a 8 Amp BEC. The jitter (i had it also) other people wrote from, is mostly because the wires of the motor are a bit fragile and easy to break, so dont bend them to often or replace them to more flexible ones (I did ;) - but you need to have a bit of soldering skills).
Regards
Fame

• Overall
• Quality
• Value

Customer Rated

Dec 23, 2011

I ordered 2 of them. Both are not working, when I input throttle,they just jitter and strugles to move. I have try to put different timing seting on my turnigy plush 6A ESC but no use. Dont buy it....

• Overall
• Quality
• Value

Customer Rated

Nov 28, 2011

I have bought 2 of theese motors and 2 Turnigy 6A plush ESC for my projects. But both of theese motors dont want to work. They jitters very slowly and dont spin... I get them to work every 5-10 throttle inputs, but most of the time they jitters slowly and gets very hot.
Also one of the motors shaft is bend.
Very bad quality....

• Overall
• Quality
• Value

Customer Rated

Oct 14, 2011

I just connected this motor to the TURNIGY Plush 6A and it just jitters back a forward when I accelerate, I tried again in 2 more ESC's with no results.