Hobbyking 3D-Drucker Filament 1.75mm Metall-Verbund 0,5 kg Spule (Red Copper)

• Overall
• Quality
• Value

Wow looks great!

Dec 05, 2018

It looks great, almost like gold and very shiny on the spool. Tends to have a rough finish but it may do better at a higher print temperature. Melts to a very liquid state if heated for a while in the hotend. Good layer bonding even at 200C.

• Overall
• Quality
• Value

A beautiful metallic shiny surface

Feb 03, 2018

Needs 215 or higher temp to give that shiny look. At this temp a bit too much oozing. Can be compensated with a long and fast retract setting with bowden extruders. At lower temps (200) the surface turns to a darker matte finish and the oozing stops. So you can play with the temp to get the desired finish. The material is a bit brittle, so it is best for decoration things, works well to print a nice vase or a figure.

• Overall
• Quality
• Value

Great looks

Oct 10, 2017

This filament prints flawlessly with extruder set to 210 C and bed 50 C.
But be careful if you pull it slightly hard, it will snap.