Micro Scharniere - 10pcs / bag

Utile pour les indoors. Je les utlise en complment avec les charnires en scotch surtout aux ailerons. Le guignol tire souvent de trop aux ailerons et dcolle le scotch. Je pose cette charnire au plus prs du guignol ce qui supprime l'effort.

Gear for foam board scratch builds. Even easier than paper hinges.. Just make a slit across the joint, and glue them in.

Weighed to 0.14gr a piece, so merit the term "micro". Max width 7.8mm over the plate. Depth of ridge that goes into the wing and control surface is 3mm. Smal play only when tugging at it, a lot more play sideways (need at least two for a control surface I would say). Good for small and light models. Deduct one star for the play.

Installed 2 of these on the rudder of my 30 inch 3D foam board model. The top hinge broke in flight and caused the model to tailfish violently until it cart-wheeled on the ground. :-( Figured it was bad luck so I repaired and reinstalled the rudder with 3 of these hinges and some tape across the hingeline as a backup. Had a very mild unrelated nose crash that did not require any repair except for 2 of the 3 hinges on the rudder. The rudder did not impact anything, the inertia of the dollard-tree foamboard rudder was enough to snap 2 of the 3 hinges. Use only on very small and light models, they snap very easily.

Very good for making rudder or elevator with 3mm thickness!

Perfekte Ersatzscharniere fr meine Triatania

These feel very fragile so id only use these for very small and lightweight planes,(im sure they were ment for those anyways hehehehe) .Just glue them on and off ya go :D

Small but strong and very light.

Micro hinges for indoor and Parkflyer use. Can be CA'd in place.

timo para linkar tampas que do acesso a baterias, ESC e receptor