Hobbyking 3D-Drucker Filament 1.75mm PA Nylon 1.0KG Spool (weiß)

• Overall
• Quality
• Value

Good for specific applications

Feb 25, 2019

Despite of fact, that filament has been sealed in vacuum package, it needed to be dried before printing.
Usable temp range for me was 260-275. With lower temp I get good finish quality and very bad layer adhesion and on 275 vice versa. Decided to use 270 °C but still layer adhesion is still worse than for example PETG/ABS. I used Volcano hotend so for V6 temps temp can be +5 or 10 °C/
Immediately after printing is print very soft but let it absorb some humidity outside and it will become very strong. Definitely better strenght than PLA/ABS/PETG, except weak layer adhesion, so properly set print direction.
For bed adhesion I was successful with bed on 100°C, use 3-4 layers of gluestick and 5mm brim. Otherwise it tends to warp a lot.
Prints are a bit stringy.
Overall I am recommending to use it for functional parts which will not be stressing layer bonds.