Lieferant werden Blog Neue Artikel
Registrieren

Gesamtpreis

0,00 €

Warenkorb 0 Warenkorb 0 Loading...

Skymaster Plug-and-Fly-Trainer (Balsa)

Generating Links

Skymaster Plug-and-Fly-Trainer (Balsa)

Preis:

Now save speichern 0,00 € 0,00 €

85,16 €
Bereits gekauft Discontinued Product

Please continue searching for a similar product.
SKU:
9126000001
Kostenloser Versand? Klicke hier um mehr zu lernen!

Der Hobbyking Skymaster ist ein traditionell gebautes, vorgedachte Balsa-Trainer mit einem Unterschied, wobei Stecker und fliegen, fast die ganze harte Arbeit ist bereits getan worden!

Der Skymaster ist ein schnell zu bauen, auch für einen Anfänger, der bürstenlose Aussenläufer Motor, Regler und die meisten Servos sind bereits vorinstalliert sind, folgen Sie einfach den beiliegenden Anweisungen und Sie werden in kürzester Zeit in der Luft! Als ein traditionelles Blatt zu bauen, die Skymaster robust und leicht zu reparieren ist, sollten Sie einen oops Moment haben, wissen wir, fliegen wir ein fast jedes Wochenende! Das Fahrwerk ist die richtige Klavierdraht und ist so hart es etwas bis zu 4 "leichte Räder selbst für die fiesen Flugplätze umgehen kann!

Der Skymaster hat viel Power und Griffe hervorragend, so gut, dass, sobald ein neuer Pilot es geschafft hat, in den Griff mit den Grundlagen zu bekommen, ein Film der Tarife wechseln und Sie haben eine brillante kleine Sport-Modell für grundlegende Kunstflugmanöver zu meistern. Der Skymaster ist ein fantastisches Flugmodell mit dem gewissen "Etwas", das nur Balsa-Modelle bieten kann, Spaß & hart mit großer Leistung, ist dies der ideale Allrounder sowohl für den Verein airstrip oder für Parkfly!

Eigenschaften:
Traditionelle Balsaholzausführung mit Tough Sheeted Rumpfs
Schnelle Bauzeit
Plug-and-Fly - einfach hinzufügen Reciever & Lipo (nicht im Lieferumfang enthalten) und Fly!
Tough Klavierdraht Fahrwerk
Ausgezeichnete Ground Handling
Voll Vier-Kanal-Steuerung
Kunstflug-fähig
Viel Strom aus der vormontiertem Brushless Outrunner
Fachmännisch angewendet mit ausgezeichneter Orientierung Regelung für

Specs:
Spannweite: 1004mm
Länge: 750 mm
Fliegen Gewicht: 500g
Servo: 9g x 3
Motor: 2822 Brushless Outrunner 1200KV
ESC: 20A w / BEC

Eingeschlossen sind:
Alle Hardware, Propsaver & Prop
Anleitung
Abziehbilder

Benötigt:
Ihre eigenen 4-Kanal-Transmitter & Reciever
1300mAh 3s Lipo Akku

  • Skymaster Plug and Fly Trainer
Video hochladen

Registrieren Sie sich bitte, um Videos hochzuladen anmelden oder Registrieren

Themen
Sortieren nach
Neueste Themen
* Nickname:

* Deine Antwort:


Geben Sie den im Bild gezeigten Text in das Feld unten ein
*Verifizierungs-Schlüssel:
Abbrechen
Senden
Poste ein neues Thema
* Nickname:

* Dein Thema:



Geben Sie den im Bild gezeigten Text in das Feld unten ein
*Verifizierungs-Schlüssel:
Beitragsthema

Registrieren Sie sich bitte, um Bewertungen zu schreiben anmelden oder registrieren

ear1pro | Verifizierter Käufer

  • Overall
  • Quality
  • Value

Customer Rated

Apr 03, 2013

Very good trainer plane, I was conversion it, using glow.10, without fuel 800gr, using MA 7x5 fly arround 25 minutes. good and stable flight even windy. It's my favourite plane!!!

Jani | Verifizierter Käufer

  • Overall
  • Quality
  • Value

Customer Rated

Jul 24, 2012

Really good trainer. Easy and very fun to fly. This is also hard to damage (I crashed it on trees several times and still goes on).

Be sure to check all motor screws before fly.

Digger313 | Verifizierter Käufer

  • Overall
  • Quality
  • Value

Certified Buyer Rated

Jun 22, 2012

I bought 2 of thoes, Very easy to set up and very for anyone to fly, very good for beginners.

Elmer | Verifizierter Käufer

  • Overall
  • Quality
  • Value

Customer Rated

Jun 17, 2012

Using a battery with 1300mhA 3s-15C can generated aprox. 19.5 Amps. This is very close to the capacity of the ESC (20A). I ordered one of the recommended batteries 1300mhA-3s-25C this could generated aprox. 32.5 Amps. Can this blow the ESC? Or is the max amps of the motor that should be below the max amps of the ESC (I read the rule of the 10pcnt)?
Thanks

Elmer | Verifizierter Käufer

  • Overall
  • Quality
  • Value

Customer Rated

Jun 16, 2012

The motor set screws got loose and the motor flew off even before fly. Luck? I recommend locking fluid on these screws since the same issue has been reported by others. Hope, a factory fix for new models.

| Verifizierter Käufer

  • Overall
  • Quality
  • Value

Certified Buyer Rated

Jun 14, 2012

this is an excelent plane with oodles of power perfect for learning on. just set up as recommended.

shellby0351 | Verifizierter Käufer

  • Overall
  • Quality
  • Value

Certified Buyer Rated

May 29, 2012

Surprisingly good build quality, fuselage made out of 3mm ply. Glued both the main wing and tail, setup all servos had to make some modifications to the rods exiting the rear of the fuselage, made adjustment to elevator to suit the tail wheel. Had to move the rudder servo as the length of the control rod to rudder was too short. Set up with OrangeRx R415 Spektrum DSM2 Compatible 4Ch Micro Receiver and Turnigy 1500mAh 3S and as the manual didnt state the CG, set up at 1/3 of the wing width to which was 53mm, flight times around 10 minutes with the battery as far up the front as possible and this will be good for the beginner; I would purchase a spare prop and O rings as I can see this being the weak point for the beginner. 10 out of 10 for this one

cxgiaco | Verifizierter Käufer

  • Overall
  • Quality
  • Value

Customer Rated

May 23, 2012

Absolutely wonderful trainer! Came in the mail with other stuff, packed very carefully, with no damage. Construction was simple, though instructions are poor at best. Switched wheels per the HK suggestion. Proper CG placement required battery pack to be fully forward. I would suggest either 3S1P 2200mAh or 3S2P 1300s. Both Setups ran well, and put the CG in the sweet spot. No wing drop on stalls, takeoff in ~25ft on dirt (baseball diamond). Never had to go to low rates. May switch out the floppy prop adapter for better thrust response, but it makes sense for a trainer. Best value on the market for a balsa trainer.

coolzed | Verifizierter Käufer

  • Overall
  • Quality
  • Value

Certified Buyer Rated

May 23, 2012

excellent avion. Facile a voler, beaucoup de puissance pour dcoller. Facile a assembler. S'assemble environ en 2hrs mme pour un dbutant. Le prix est vraiment interessant pour apprendre a voler et faire quelques acrobaties. Hobbyking est incontestablement un adversaire de taile dans le domaine des avion tlguid!!

Heliosphere | Verifizierter Käufer

  • Overall
  • Quality
  • Value

Customer Rated

May 21, 2012

The Skymaster is my first balsa plane, after first owning foamies like the Bixler and Tek Sumo.



Out of the box I was very impressed with the quality. The covering looks great. Everything went together fairly easily, the only slight problem was that the main landing gear rods were slightly too long to fit flush with the fuselage. Had to get the Dremel cut-off wheel out and trim a few millimetres off for it to sit right.



One thing that is not good enough is that the manual doesn't mention a centre of gravity. Come on hobbyking that's a pretty important thing to include, especially for a trainer! I ended up entering all the measurements in an online CG calculator and decided on starting with a CG of 42 mm. It took a 1.8 Ah battery all the way forwards to balance at that point, so significantly more battery than the suggested 1.3. I'll try a 1.6 next to see how that affects flight.



I was a bit nervous with my first flight of a plane with wheels, but the skymaster made it easy. It flies great, feels a bit more "solid" in the air than the foam planes I've flown previously. Seems to be very forgiving on landings, a couple of mine have tested the landing gear, but there's a decent amount of spring in them to soak up the force. The 75 mm foam wheels worked great on the longer grass but I'm flying from.

  1. 1
  2. 2
Kundendateien
Skymaster instructions Download [1807]
Datei hochladen

Registrieren Sie sich, um Dateien hochzuladen.
Bitte anmelden oder registrieren um jetzt Hobbyisten zu helfen!

Zubehör