Turnigy Marine-120A Brushless Boot ESC

• Overall
• Quality
• Value

Customer Rated

Apr 03, 2015

Trs bon produit.
Il chauffe peu, si bien utilis trs fiable.
Vous pouvez y aller les yeux ferms.
C'est un hobbywing seaking rebadge.

• Overall
• Quality
• Value

Customer Rated

Jan 04, 2015

I purchased this to replace the stock Proboat speedo that came with the BlackJack 29 version2. Raced it last weekend and it performed flaulessly. After a 4 min LSO race on 4s it temped at 119 degrees F. Not too shabby. I am going to disconnect the eternal BEC and run a lipo receiver pack and it should run even cooler. It is the perfect size for the boat. Great choice and price. I received it to Florida in less than 10 days from intl warehouse.

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 11, 2014

It cames without connectors, you must buy them separately and solder them in place. The cables are 12 AWG. I will use this ESC on a Pursuit.

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 09, 2014

Nothing but the best from turnigy , will be ordering there aquastar 200a to run 8s-10s in my genesis . Very pleased with my 120a esc stays cool and doesnet dissapoint :)

• Overall
• Quality
• Value

Customer Rated

Jul 13, 2014

I LOVE expensive FIRES ON BOATS while on 40 - 50 Km/h. Well this is what this ESC did on mine.

To the point:
Well the esc cannot be used at the stated ratings. I used it with a 6s setup and a 80 A max motor. ESC burned up after 3 x 6 min sessions in consecutive days. The temperature of the ESC never exceeded 30-40deg when I checked it after a fast run. .I would say safely maximum 4s setup on 80 A.

• Overall
• Quality
• Value

Customer Rated

May 11, 2014

Brought 8 of these now had one faulty one that lasted a setup then died. Run these on 5s using Bec no problems. I have installed these into two twin powered cats. Have used these in the outerlimits on 5s with 40mm prop. Run boat flat out full throttle for 3 mins esc and motor came in cold I start on zero timing then work up from there also remove low voltage as this can case some issues

• Overall
• Quality
• Value

Customer Rated

Apr 29, 2014

I use 3 of this in different boats and I always used the internal BEC. Up to 5S I had no problems. Whith 6S the ESC explodet at the first full throotle and destroyed my 500 Boat.
No over temp no over current protection worked. I am not sure if this is related to the use of the internal BEC.

• Overall
• Quality
• Value

Customer Rated

Apr 16, 2014

Most of the international Race Boat Pilots prefer this ESC .
I used it for 2 Years in a 6s 120Km/h setup w a Tenshok motor.

I had to install stronger condensers 4x 470 uF with 35V directly sold to the main wires , otherwise the Motor stuttered .

Sadly the ESC gave up the last days because the BEC burned and defected the whole ESC.
I ran it already with Ubec (a need over 3s).Therefore I deinstalled the red wire.
But even then the internal BEC is working and damaged the ESC.
There should be a jumper to disconnect the whole BEC while not needed in the setup.
Even then its one of the beste ESC to get on the market !

• Overall
• Quality
• Value

Customer Rated

Mar 30, 2014

Great esc,, running on 5s,, 28mm jet drive and a 3660SL 3180kv Brushless Inrunner ,,
Plenty of poke when you need it :)
http://youtu.be/1B8Xcci2JYI

• Overall
• Quality
• Value

Customer Rated

Mar 30, 2014

<object width="560" height="315"><param name="movie" value="//www.youtube.com/v/1B8Xcci2JYI?version=3&hl=en_US"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="//www.youtube.com/v/1B8Xcci2JYI?version=3&hl=en_US" type="application/x-shockwave-flash" width="560" height="315" allowscriptaccess="always" allowfullscreen="true"></embed></object>