Looking for a multi charge plug that incorporates EC5 and XT90 connectors as well as the commonly used connector types? look no further! The multi charge plug adapter set is the perfect solution for those who like the larger battery connectors but still require the flexibility of other multi adapters.
Suits batteries fitted with the following plugs:
Futaba style plug
Glow plug connector
PB / lead acid batteries (croc clips)
Charge Lead Length: 390mm
these cables does the job but beware of crocodiles pliers as the easily can shortcut.
for better use I will replace these with HXT 4mm that disappear on this version as EC3 did too.
Having XT90 is good as it's the new hobbiking standard for lipo connector beginnig at 3s.
Don't use Glow or Tamia, also think it was a good idea to provide XT30 and JR/Futaba connector; I know for this last thing that I can cut a little bit of platic to fit the connector on this lead.However not perfect good for the price.very helpp this cubels exlentGewicht 96g
Kebellaenge ca 28cm ohne Stecker
alle Kabel ausreichend elastisch
EC3 ist nicht dabei, nur EC5
Not a great charge lead. I bought it because I needed the glow plug starter charge lead. Biggest flaw I have found thus far is that the alligator clamps stick out past their protective boots. This can lead to some serious arcing problems. I haven't gone over it to verify the leads are all in the right position. to and - to -. Also the main wire seems on the small side which may be of some concern if charging a large pack.Good Multi Charge Plug Adapter set, only Tx charge connectors are missing. It would be nice if there were Tx charge connectors for Futaba and JR type Tx.Pay close attention!!
I have bought two, and the two arrived with the Mini Tamiya leads on the wrong place.
The red in the place of black, and the black in the place of the red.
Careful not to make short-circuit.