12 Channel Tx/Rx video system with CCD camera.
The camera uses a quality glass lensed SONY CCD camera system.Unlike other generic systems, we have produced a wiring loom and included it with the camera so that the Tx and camera will be compatible and on the same voltage.
If you buy your camera and Tx seperately the plug polarity and voltages may be very different.Included.
1 x SONY CCD 1/3inch Camera
1 x 2.4GHz 4 channel Video Transmitter (100mW)1 x 2.4GHz 12 channel Video ReceiverCamera spec.CCD sensor type:1/3 color SONY CCD
PAL: 500(H)*582(V) (Included)
Scanning system: Interlaced scanning
Horizontal resolution: 420TV line
Minimum Illumination 0.01LUX/F1.2
S/N Ratio: 48dB
Gamma Modification: 0.45
White balance: Auto
Auto backlight compensation: Auto
Input voltage: 9~12.6V
Electric current 80MA
Electronic Shutter: 1/50 (60) ~ 1/100,000s
Video output: 1.0VP-P composite video
Operation Temp.: -20~50
Flight time: Approx 60min/100mah 3SFPV Tx Spec.
Channel: 4-Ch, AV synchronization
Input voltage: 8~12V
Weight: 29.9gSize: 41x28x16mm
Frequency: 2.4G 2.410G/2.430G/2.450G/2.470G
WARNING : verify the connector on the camera, mine came in the wrong side, i have to remove the white part and put it back reversed, you have to get the RED wire on and the WHITE wire on VOUT !
i did not test range but quality seems good, low light sensibility too
colors are not accurate under artificial light (not yet tested under real sun)Excellent pour le prix. Il est opportun de changer les antennes pour des "cloverleaf" polarisation circulaire. Bilan, une porte sol teste impeccable 1 km (sur une plage), c'est largement suffisant pour s'amuser. L'metteur fonctionne sans son botier alu, attention il chauffe pas mal dans ce cas. Et il est sensible aux chocs et vibrations, qui provoquent des lignes horizontales dans la transmission. Idal pour commencer en FPV, mais attention ne pas avoir une radiocommande sur la gamme 2,4 GHz ! Perso je suis rest en techno FM, en 41 MHz, c'est tout bon!It is the best fpv product in relation Price-quality that I have seen. I test the range on the ground with stock antenas and is about 300 meters. The camera is also good, and if you test it on de dark the camera active the night mode.I recently received this package, and decided to put it together. I couldn't find a connector for the receiver, until after a couple of days, when I saw my broken speaker-set. Then the polarity came into play.
Anyways, I just managed to solder different connectors on the place of the JSTs (so that I can add the same on each esc cable), and, when finished, hooked it up to my TV. I now remember reading that the plug on the cam is on the wrong way around (but could handle 12v on Vout). Then I saw that the board said - Vout, plugged it in the wrong way anyways, print could've been wrong. It wasn't. Swapping out the connector without tools at hand is painful, but worth it.
Haven't flown with it yet, as my RC system is down atm, but certainly am looking forward to (I have to mention that the video transmission wasn't perfect, with the Rx right next to a WiFi router). Will edit rating if the transmission sucks (diff. antennas can solve the prob)Very good, just watch out for cables to the camera. Video output and the positive polarity to the camera are reversed. You must replace them. Then it goes to 100pcntMy system like this don't work :(
I recive in the mail my last shipment whith this camera kit and when i plug it to the tv nothing happen
Please tell me that it s a solutionHi, recieved my tx/rx kit a few days ago, just tested it yesterday.
It works fine, range is quite short (50-100meters), but it was not in a clear field(tx was in my room, and I was walking in the street with my tv and RX)
When I plugged it first it refused to work, you have to be carefull they had reversed the camera plug, be sure that the mentions VOUT;-; on the camera board match respectively the white;black;red wiresfor the camera.
If your plug is reversed, just pull it of with clipers and turn it 180.
Je viens de recevoir mon kit, il fonctionne correctemnt, j'ai une porte d'environ 50-100m d'origine avec de nombreux obstacles (maisons, voitures...)
A l'origine la camera ne fonctionnait pas, le detrompeur blanc sur la carte de la camera etait mont l'envers, bien verifier que les mentions Vout;-; sur la carte de la camera correspondent aux fils blanc;noir;rouge.
Si votre connecteur est invers, tirez dessu avec des pinces et retournez le 180I've got incorrectly wired camera connector ( 12v and video wires was changed one with other). I'm very disappointed with it.
What is surprising, it started to work after I fixed the problem. Picture's quality is OK for me, distance too.First I got no picture but after fiddling with the system it turned out the camera included was DOA. So much for the QC, but my GoPro hooked to the TxRx worked fine and provided a good picture on a small 7 inch monitor. Ill stick with the GoPro and the cam goes to the bin.Becareful of the cheap lens that HobbyKing says is high quality glass lens for the sony cdd camera! They are useless for FPV! I have complained but they dont listen or dont want to rectify the bad lens supplied with the camera. http://malaysia-rc.com/index.php?topic=23360.0