2 Pin JST plug with 6 x Pico plug charging harness.
Charge up to 6 mini cells at once.
Great for Parkzone Eflite bind & fly aircraft batteries!
Used to create my own xh 3 cell balance charge cord. The extra leads used to replace some by worn down pins on some umx leads on a few FC's on my mini quads. Worked out just fineNeeded some battery connectors for the ParkZone / Turnigy "gumstick" batteries. Bought one of these and snipped off the JST connector. Works great! I have some others that I use to charge batteries and no complaint there either! The wire is fairly stiff unfortunately, but you can cut the wire at the connector pins and solder on your own wire.Good quality, allows charging 6 batteries with pico connector at the same time.Good to have if you want to charge bunch of Champ/E-flite batteries at once. I'd recommend to add a drop of CA glue to the back of connector - pins sometimes come off.
Visual quality is not the best, but these harnesses to the job very well and even better than "parallel board": They can be folded and are easy to pack inside the tiny box of my e_Flite blade msr.works great for charging multiple single cells at the same timeGreat and simple cable for saving some charging time. This will not let you balance the cells, but connect them in parallel and chargeVery handy or a cheap way to get the Pico plug if you need some. A version with a Balance plug would make it awesomeI bought this cause i needed to charge only 1 1s nano tech 160 mah battery, but i purchased 2 battery and i was worried about to try charging both 2 at same time.. but nothing gone wrong so.. you can do it too.
All connectors seem ok very little but well made very cheap.. so no worriesGot this to charge the 1s batteries for my Blade Nano Qx. Its great being able to charge 6 at once with my normal lipo charger instead of one at a time with the usb.