The Flycolor 4in1 30A system is an outstanding combination specifically designed for multirotor drones. It comes complete with four 30A ESC’s, a power distribution board (PDB), an F3 Flight Controller and a BEC (5V and 12V). All components can be individually replaced if they become faulty.
The 30A ESCs use BLHeli firmware for easy setup and provide a smooth, linear and precise response. The F3 flight controller can be used in PWM, PPM or SBUS modes and comes with a built-in buzzer. Another feature is the BEC which gives 5V/3A and 12V/1A output. Easily providing power to camera, VTx and LED’s.
Compact and lightweight, it won´t add any extra burden to your drone. Don´t hesitate to get one!
• ESC, flight controller, and power board can be replaced independently for easier assembly and repair
• Specially developed for multirotor aircraft
• Plug-in type F3 flight controller with alarm
• High-performance MCU processor
• Flash BLHeli for ESC via flight control directly
• Compatible with BLHELI firmware
• BEC provides 5V/3A and 12V/1A
Current: 30A per ESC
BEC: 5V/3A, 12V/1A
Power connector: XT60
1 x Flycolor 4in1 Flight Controller, ESC, PDB, BEC
1 x Cable Set
It supports betaflight and BLheli and as far as I can tell it supports BLheli pass though, but the board esc board is MASSIVE. I intended it to go on a 215 frame, but no way was it going to fit, so I got a 250 frame an it barely fits if you leave out some of the interior frame screws. I'm still waiting on HK to respond to my claim for a return so until then it sits in my drawer.Made my project much easier to build. Neat and tidy. Works perfectly would highly recommendWatch out on the width of this ESC, if ou intend using on smaller 210mm quad, you may find the board is wider than your bottom plate. Measure carefully first. However, for the lazy person this is perfect! ESC are soldered onto the bottom PCB, so in theory they can be replaced individually, if HK were to stock them?