3W Red LED Alloy Light Strip 120mm x 10mm (2S-3S Compatible)
This LED light strip is super bright even on 7.4v 2S battery and is great for multi-rotors, planes and other types of models. These light strips are so bright that they can be used in daylight as well as at night and the light angle is extremely good unlike some lights which are very directional. Another feature is that these light strips can be joined together to extend the length, this does require some soldering.
Dimensions: 120 x 10mm
beam angle: 120 degree
Color temperature: 620-625nm
Operating Voltage: 7.4-11.1v
Max Voltage: 13.5V
Luminous flux: 400-450LM
Color rendering index: 70-85
Material: Aluminum plate
Service life: 50000 hours
Operating temperature: -20 - +60 degree Celsius*Note: please make sure current draw is lower than 280mA or you risk damaging the LED strip
- Blade Count:
Fantastic LED strip. Very dense array of chips so it looks solid from only a short distance away. Do keep an eye on current and voltage in though. On a 4S setup I was tempted to use the 12V out that my PDB supplies, but on closer examination that was a low-current linear regulated voltage intended for FPV equipment. I used a small, standalone, buck converter set to 12v instead.these can easily be wired directly to battery, they've got their own current limiting circuit board. They are seriously bright on 12.6V, and also act as an easy voltage alarm on my quad cause they get very dull at around 10.5V.Extrem hell. Kann sehr warm werden, also nicht mit Klebeband befestigen.Intense on 3s is an understatement lol, very bright. I just completed a nighthawk250 build and installed the strip centered on the bottom plate, perfect length. IMHO, too bright, hurts my eyes. Going to run a resistor to drop voltage down to about 9v and see how that goes. Going 4s soon, so resistor will def be needed then. It would probably be like staring into the sun on 4s until it burns up haha.Besser nicht fr 250 Qadcopter kaufen. Sind sehr schwer aufgrund des Alus. Leuchten aber verdammt hell. Zertrennen bzw. krzen geht NICHT. Habs versucht und mir eine Leuchte damit verzackt. Auch die Enden wieder zusammen lten ist nicht mglich.
3W is to bright for the night below 20 meter observation distance. In the aylight is perfectNice and bright, looks awesome on my mini quad!Was very excited to finally get this in after the usual 10 day shipping wait.
Plugged into a 2S battery and was very disappointed to see that 2 of the leds do not light up.
The led that do light up are a brilliant red and look great. But the fact that there's a small gap in the led bar light is unacceptable.
As this is the first one i've ordered the defects are 1 for 1.
Will be submitting an RMAplusplusottimo prodotto ben fatto leggero e robusto100pcnt. If you fly LOS