Basher Nitro Circus MT - Front Suspension Arms

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 22, 2016

Basher Nitro Circus MT - Front Suspension

• Overall
• Quality
• Value

Customer Rated

Mar 21, 2015

Used as hopup for Sabertooth. All connections are the same, except arm pins that are 5 instead of 4mm, and no droop screw holes (because of different arm design it's not even possible to drill them by yourself). You also have to use Nitro Circuis pins, pin holders & bumpers to mount them, since stock sabertooth ones, even if you increase the pin holes don't have enough clearance. Much stronger / less flex that the sabartooth ones and of course no more problems with broken pins & bent dogbones/cvd's!

• Overall
• Quality
• Value

Customer Rated

Feb 11, 2015

These are not the arms described in the manual's parts list or blown up diagram. If you look there, both front and rear arms should have droop screws mounted. There's no hole for such in these.

• Overall
• Quality
• Value

Customer Rated

Jan 30, 2015

On geometry coincide with levers for SaberTootn. But thicker 1mm = 11.7 vs. 10.7. And hole for the axis is of 5 mm vs. 4 mm SaberTootn. With minor alterations or replacement axle mounts and axis from Circus MT are suitable for installation on SaberTootn - this will be enhanced version :)