Do you want deadly performance for your multirotor? The Black Widow Series of motors have been specifically designed for multi-rotor racing when only the best will do.
More compact, lighter and with greater efficiency, Black Widow motors are premium motor systems incorporating both the motor and ESC into a single unit. This saves space, reduces overall weight of the model, reduces drag and allows the system to run cooler.
Wth the built in ESC you can also change the direction of rotation of these motors with a simple flick of a switch and there is also a USB compatible flashport at the base of the unit that will allow you to update the firmware.
These crisp looking units have been manufactured to exacting standards and use original NMB bearings to ensure the smoothest running and reliability of the motor. Quality mounting accessories are of course included and multiple mounting holes cater for most multi-rotor frames currently on the market.
If you are into FPV racing and want motors with real bite in performance then its hard to go past the Black Widow Series.
• All in one motor with built-in ESC
• Built-in reversing switch
• Built-in flashing port for firmware upgrades
• Fast throttle response
• High efficiency
• CNC case for durability
• 0.2mm thickness silicon steel sheet used for stator which creates low current loss
• NMB bearings for durability and smooth running
• NdFeB high temperature rated magnets for trouble free operation
• Dynamically balanced
• Compact and lightweight
• Low internal resistance
• All in one unit keeps wiring neat and tidy
Model Name: 2204 18A
ESC Current: 18A
BEC Output: No
ESC Battery cell:2-3S Lipo
Motor KV: 1900KV
Size: 27.5 x 19.4
Recommend prop size: 5-6"
1 x ZTW Black Widow 2204 18A Motor With Integrated BLHeli ESC
1 x Manual
Max Currents (A)
Length B (mm):
Can Length D(mm)
Unit Weight (g):
Total Length E(mm)
No physical reversal switch like stated in description.
1900KV motors is what is labeled on these (as opposed to the 1000kv in the listed picture.
Bought to upgrade a tweaker180 quad. Along with HK's Betaflight F4 FC for a simple rebuild.
My only issues thus far is that all the motors 'twitch' and 'squeal' when powered with no throttle. I have seperatly set min ppm min throttle in the blheli suite, min throttle and min command in betaflight, which helps a little but not completely.
Need a little longer with these motors.
Posted a screen shot of the factory settings that I pulled up via BLheli before I had to customize settings, over in the files tab.
First of all, there is no reverse switch that I could find unless it is inside the motor. I reversed direction with BLheli suite.
I ordered 8 of these motors and after finishing my special build I tested out the motors and they run very rough and do not hold a steady speed. only at full throttle do they spin smoothly.
I do not think it is the motor but more likely to be the esc. I have tried 5 of the motors and they all run the same. I even hooked one up directly to a receiver and it was just as rough and jerky with no smooth response and did not keep consistent speed. they are just as bad with props on or off.I run this motor with Carbon Fiber Propellers 5040 Self Tightening (CW/CCW) (1pair) ,and it works great in my 250 quadcopter and its not getting hot. ESC good responce, good job.
Factory settings, ignore the differing PPM max throttle settings download now [53.29Kb]