A perfect brushless system for any 1/8 scale car, truck, or buggy.The specially designed motor gives more run time and comes with thermal protection.Brushless Electronic Speed Controller(ESC).
Execellent throttle response, acceleration, strong brakes and throttle linearity
Programable with a B6090 programming card to make adjustments.
Automatically detects the number of cells within the battery pack.
Multiple protection features: Low voltage cut-off protection, over-heat protection, throttle signal loss protection.
Reverse power (Off, Low, Medium, Hi)
Start power (Standard, Low, Medium, Hi)
Drag (Neutral) Brake (Off, Low, Medium, Hi)
Battery type (Ni-mh, Ni-cd, Li-xx)
Default, Manual settings
Continuous Current: 7.4V/45A/333W
Burst Current: 90A
Resistance: 0.016 ohm
Suitable Car: 1/10 on and off road.
Battery: 7.4V 2cell Lipo / NI-xx
Bec output: 5V/2A
Dimension: 51 x 25 x 13.5mm
Motor: 540SS 4000kv
Type: Sensorless brushless motor
Max operating current: 60A
Max operating speed: 7.4V/31080rpm
Max efficiency 80%bmax.
Shaft length: 15.15mm
Shaft size: 3.17mm
ESC: 1 x 45A
Motor: 1 x B221T40 (4000Kv)
It's fit with my 1/10 Kyosho fazer, very powerful and fun, but little difficult to control the speed and steering because the output power is so wild.My first brushless Car System - cannot make comparison for other systems. I use on 1/10 offroad - loads of power.
But be warned: back of the motor is supposed to be held by 3 M2 screws. Those were missing and back bearing dropped down from motor during second run (was only held by some glue). Could have caused severe damage!
This is why this system only gets 3 Stars.This motor is not for a 1/8th setup. The size, KV and shaft size all fit a 1/10th scale setup. Check your specs before buying a motor to make sure it fits your application.