A perfect brushless system for any 1/8 scale car, truck, or buggy.The specially designed motor gives more run time and comes with thermal protection.Brushless Electronic Speed Controller(ESC).
Execellent throttle response, acceleration, strong brakes and throttle linearity
Programable with a B6090 programming card to make adjustments.
Automatically detects the number of cells within the battery pack.
Multiple protection features: Low voltage cut-off protection, over-heat protection, throttle signal loss protection.
Reverse power (Off, Low, Medium, Hi)
Start power (Standard, Low, Medium, Hi)
Drag (Neutral) Brake (Off, Low, Medium, Hi)
Battery type (Ni-mh, Ni-cd, Li-xx)
Default, Manual settings
Continuous Current: 7.4V/75A/555W
Burst Current: 150A
Resistance: 0.0166 ohm
Suitable Car: 1/10 on and off road.
Battery: 7.4V 2cell Lipo / NI-xx
Bec output: 5V/2A
Dimension: 29 x 37 x 37mm
Motor: 540SS 5000kv
Type: Sensorless brushless motor
Max operating current: 60A
Max operating speed: 7.4V/44400rpm
Max efficiency 80%bmax.
Shaft length: 15.5mm
Shaft size: 3.17mm
ESC: 1 x 75A
Motor: 1 x B221C50 (5000Kv)
damn, this IS powerful. I had to set my short course to "dragster profile", ass up an head down, to keep a bit of control when accelerating.excellent brushless system, motor is very smooth and has little resistance when hand turning the shaft, however, once run, it does provide plenty of torque to give wheelies on my desert truck. Esc does not even get warm from running 2S lipo, motor does get warm after 5-10 mins of running with lipo. Programming card is very nice. only complaint is that the phillips screws on the esc are almost stripped and very hard to remove in order to mount the fan, should have used harder steel for the screws, but other than that, great product.This setup is for a 1/10th scale not a 1/8th scale. From the dimensions of the motor and the shaft size. For 1/8th scale you want a 5mm shaft not the 3.17mm which will fit a 1/10th scale pinion gear.