Car cigarette lighter adapter for 12v chargers.
Adapter includes two size 12v plugs and will fit our Turnigy, Imax, Emax and other chargers.
Outside diameter: 5.49mm
Inside diameter: 2.52mm
Outside diameter: 5.49mm
Inside diameter: 2.12mm
Max current: 12A, 25V
A great way to supply power to chargers without lifting the bonet of your car! Or, for those that like charging packs in the car on the way to the field.
Do not use more than 50W. (about 3,600mAh 3S @1C charge)
Please ignore the labels that say 'Futaba' and 'JR'. For some reason the factory believed you can charge your transmitter with a 12V car power supply.
DO NOT CONNECT THIS TO YOUR TRANSMITTER!
IT IS TO POWER BATTERY CHARGERS ONLY.
The label is helpful in inidcating polarity of the plugs, however.
Perfecto para no abrir el capo del coche a la hora de cargar las baterías en el campo de vuelo, aunque tened cuidado cuando dejéis todo dentro del coche.Insides have melted and it was only powering a IMAX B6 Genuine charger too on a 4 amp PB Charge...??
Internal Fuse failed to blow so casing spring fuse melted beyond repair....
Just glad it didn't catch fire !!Meh. I didn't even buy it for its intended use. The quality on this one is below other HobbyKing connectors and adapters. Not silicone wire. Very thin gauge. Connectors installed with reverse polarity. Bleh.The wire is not silicone, and not marked with a gauge or temp rating. It's actually really thin gauge wire with a thick cable housing. It's alright, but from what other reviewers say, it's not actually even that good for its intended use, because one of the two plugs is reversed polarity from what's needed.I purchased one of these because it was listed as an accessory for the dlux charger I purchased. This doesn't plug directly into the charger however, so I attached an xt60 plug to use it on the dlux charger.Simple and it works not much else to say!Lead could do with being longer, but apart from that very good value.Giving this item poor ratings. I have purposely tested it with high current, and the fuse fails to open. The plastic plug will melt from heat before the fuse breaks. Keep this fire hazard in mind and you should be fine under 12v 2a load.Good material, tough built. The plug have internal replaceable 5A fuse and a led. Very dangerous the presence of two almost similar power plug with reverse polarity, be VERY careful to choose the right one for your equipment.Great product. I recomended. Excelent