Carbon Fibre Look Starter Box for 1/10 & 1/8 Nitro Car.
CF look sheet over Stainless Steel for durability
Robust Carry Handle
Top/Single Tool Adjustable Posts
Durable Rubber Flywheel
Adjustable Flywheel Engagement Point
Efficient Belt Drive System
Efficient 775 Motor driving high torque reduction system
Factory Assembled, Ready to use
Accepts 2 x 7.2v packs or 12v DC power
Handy Remote Glow Starter Storage Compartment (Glow Starter Not Included)
Full Instructions Included
Dimensions: 375mm x 85mm x 130mm
Post Height: 8mm front & rear
Pulley Ratio: 4.301:1 (13T pulley/56T Spur Pulley)
Operating Voltage: 10v~14v
Battery Type: 12v DC (Lead Acid, Gel, etc) or 14.4v (2 x 7.2v Packs in Series)
시동도 걸지 못하고, 모터 기어 일그러짐. ㅠㅠㅠ 완전 불량임.Excellent banc de démarrage, compact et léger.
Je l'utilise avec un Lipo 4s pour démarrer mon buggy 1/8 avec succès.
Il faut cependant bien fixer le moteur avant la première utilisation afin que la courroie ne glisse pas.
Les plots fournis avec le banc sont très efficaces et sont très simples à régler.
this box is a piece of garbage i would not recommend buying this...it says 775 motor driving high torque..NOT EVEN CLOSE....you could even stop this with just your thumb alone...again dont waste your money on this make sure its a twin motor...then for sure thats a high torqueBought one to use with my sabertooth nitro, but doesn't work, don't reach the flywheel. Too options: cut the chassis to enlarge the hole to flywheel, or remove pull starter and motor support. So I continue to use my pull starter.
The plastic insert are very weak, I broke one just tightening a screw...not very happy with this product! tried to turn the rubber fly wheel and motor to set it for my nitros . broke 3 wires and cut my finger . just bad all around. i haven't even put power to it afraid it will not work .The wheel on mine was crooked, so its not parallel to the slot cut-out on the frame. Its was a noticeable offset of about 10 degrees which is very bad, so bad that it wants to move the car forward and then the wear on the wheel is worn out prematurely.
Im not sure how to fix this because the mounting holes are fixed and not adjustable, and the plastic piece holding the rubber wheel and motor cant be adjusted either because they use a belt to drive the wheel.
Not sure how long this will last, but I think a replacement wheel will be needed soon.The carbon starter box must replace the plastic pulley
by a metal or aluminum for more durability.
Thanks.Really only for 1/8th scale. Starter wheel is too wide to fit through narrow flywheel slot. I was unable to setup guide posts for a 1/10th touring car, distance from push switch to starter wheel is to great.poor quality . Motor spun by itself with no load on it and adjustment screw failed to work . However i managed to sort it out with washers on the starter deck to ensure it pops back up to correct position . Now works fine and yo get what you pay forVery difficult to change orientation of starting wheel, wires to motor broke while trying to change. Had to bend outer shell to remove motor/wheel assembly. If you need to change the starter wheel for different crankshaft maybe look at a different unit. Pretty disappointed and now have a useless box as motor terminals broke off trying to fix. couldn't really recommend this to anyone.