Cellpro 4s 4A Lithium Cell Balancing Charger
Cellpro 4s 4A Lithium Cell Balancing Charger
Copy and Share the Below URL
The Cellpro 4s is simple to operate, just connect the Cellpro Revolution 4s charger between a power source and a pack. No jumpers, plugs or dials to set! Charger automatically determines pack capacity and sets optimal current, then dynamically adjusts charge rate as needed. Manual charge rates of 0.25A to 4A (in 0.25A increments) allow for special situations.
For battery type: Lithium Polymer, Lithium Ion, Lithium Manganese and A123 packs;
charger can be used with 1s to 4s packs having node connectors and
connected to charger with an appropriate adapter cable (see related products)
Pack capacity: 250mAh to 32Ah (charge time limited to maximum of 8 hours)
Input voltage: 12 to 16VDC*, reverse polarity protected
Input current: 5A minimum*
Power conversion: 62.5kHz switcher operating at 90% efficiency
Nominal output voltage: 4.20 volts per cell for all except A123 packs
3.60 volts per cell for A123 packs
Output current: Up to 4A, reverse polarity protected; 3A on 4s packs
Number of cells: (output) 1 to 4 cells in series
Cell balancing: To within 10mV
Voltage calibration: Cell voltage measurements are factory calibrated to a standard
traceable to NIST; calibration is to ±6mV
Current calibration: Charge current is factory calibrated on a 4A standard; calibration is to
±6mA
Measurement accuracy:
Voltage: ±10mV
Charge current: ±1%
Capacity added to pack: ±1%
Percent capacity (“Fuel”): ±5%
Serial data output: 19.2kbps, 8 bits, 1 start bit, 1 stop bit, no parity
NOTE: Balancing boards are sold sepperatly. Please see related products.
*WARNING: Power supply must provide at least 5A at 12V (60 Watts). Failure to comply
will void the charger warranty.
| Manual | Download [1134] |
Only registered users can upload files.
Please log in or register to start helping your fellow hobbyists today!
