CNC Aluminum Outboard Style Boat Drive w/o Motor (Suit HobbyKing H2O Style 650EP)
CNC Aluminum Outboard Style Boat Drive w/o Motor (Suit HobbyKing H2O Style 650EP)
Copy and Share the Below URL
Dress up your next racing boat project with our CNC aluminum outboard style outdrive for your 500~700mm long boat project. This faux Mercury outboard motor features a CNC aluminum lower unit, mounting system, and a fiberglass engine enclosure. A flex shaft cable runs through the lower unit, terminating a a threaded portion with drive dog. This unit is ready to accept your 28mm watercooled inrunner motor. Pre-run extended motor wires with 4mm bullet plugs, and a pre-installed water pick-up line with a water exit complete the unit.
A full set of installation and maintenance instructions are included. One cool feature is that the flex shaft assembly has a pre-installed grease tube. This means you can simply use a syringe of marine grease and inject it straight into the flex shaft without the need to dis-assemble anything. Mounting to your hull is easy, just need four bolts. The whole unit can be adjusted to fine tune the prop drive angle for optimal performance. As the whole unit, motor and all pivot on the mount, heavy duty teflon bushings reduce friction, yet are maintenance free. Pull-pull style arms reduces servo load for the utmost of precision.
Add good looks and performance to your next boat project with our CNC Aluminum Outboard Motor!
*Note: This unit is also sold with motor and can be found here
Features:
• CNC aluminum lower unit
• Painted fiberglass faux engine enclosure
• Flex shaft grease tube minimizes maintenance time
• Adjustable drive line angle for optimal boat attitude
• Teflon bushings support motor pivot shaft
Specs:
Motor Mounting Holes: 16mm
Motor Coupler Shaft Diameter: 3.17mm
Boat Size Range: 500~700mm
Weight: 148g
Motor Connectors: 4mm bullet
Required:
Boat
28mm Inrunner Watercooled Motor
50~75A Marine ESC
3~4S 11.1~14.8V 3000~4500mAh Lipoly Battery
