Corona 2.4Ghz DIY Module & RX (DSSS)Upgrade your FM/PPM radio to the new 2.4Ghz DSSS technology with a Corona DIY system.
Compatible with all Corona 2.4Ghz receivers.Spec.
Voltage : 8V - 13VWeight: 5g
Range : more than 1500m
Operating current : 100 MA
Resolution : 10bit
Latency : 22msIncluded.
I have installed 6 of these so far in my Airtronics radios and have two more to go. I wish they would come back in stock because I want to buy more.Installed on a Futaba 7c in less than a 1/2 hour. Painless installation and works great. Can't beat the price too. Follow this guide and try it for yourself:
https://www.google.com/url?sa=t&rct=j&q=&esrc=s&source=web&cd=3&cad=rja&uact=8&ved=0CDEQFjACahUKEwjj_Jjz_NXIAhVHax4KHaRLBQM&url=httppcnt3Apcnt2Fpcnt2Fwww.rccrawler.compcnt2Fforumpcnt2Felectronicspcnt2F233454-how-reveiw-futaba-7c-fm-corona-2-4ghz-conversion.html&usg=AFQjCNEmuvwL_RNpBwGXLz5yw6S6ffcedw&bvm=bv.105814755,d.dmoFinished installing in my tried and true Futaba 7CAP. Installation takes about 1/2 hour with careful work and attention to detail. Initial binding was flawless and start-up times are less than 5 seconds. Range check went well, now awaiting a first flight. Great value and will buy another. Thanks for a great product.
RichFunciona a la perfeccinExcelente producto. Lo he instalado en una Multiplex cokpit y va muy bien. Aunque aun esta trabajando sobre los 8v, me da mas de 200 metros de alcance. Estoy a la espera de un elevador de voltaje para mejorar el alcanceWorks perfect in my Sanwa M11 , made my own TX-Body with a 3D Printer and now it looks like original. To get the ppm Signal you have to press the micro switch . Open the backcover of the M11 and you can see it , I use a Sticker to keep it "pressed". Now everything is fine and works with full range.Modul CT8Z DIY mm naistalovan ve vyslai Graupner MX 12 S a spolu s pjmai Corona 6 a 8 k slu bez problmu od poloviny roku 2013. Pi provn RX a TX ped ltanm je poteby aby byla vzdlenost meiz nima cca 2m. Souprava pracue bez problmu.Mounted on an E-FLY 100C (35Mhz). Took out the crystal from the original module and the signal from the diy module was patched to the trainer port. Works excellent.This module have already been two years and no problmu.Ted I ordered another one to another radio, but I did not go zklamn.Modul switch to bind modu.Poslal I reklamaci.Ji week and no response from HobbyKing.Great system mounted on my 7CAP. Instructions are a bit bad. Range is excellent be sure to solder both joints on the module. Im not using any switch. 72 mhz and 2.4 ghz running at the same time.