The Corona R6DM 2.4GHz DMSS compatible 6Ch receiver is designed for use with JR DMSS 2.4GHz transmitters, such as XG6/XG7/XG8/XG11 and XG14 that use DMSS RF protocol.
When working in "Special mode" the R6DM can output up to 8 channels using S.bus to allow greater flexibility in performance as well as a convenient way to reduce the wire count in tight installations.
• 6 Channel micro receiver (normal mode)
• <8 channels in special mode
• Low latency
• S.bus output (special mode)
• Twin antennas for signal security
Voltage: 3.6 ~ 8.5V
Max Current: 60mA max
Operating temp: -10 ~ 70°C
Dimensions: 45 x 18 x 8mm
Pas encore testé la portée mais jamais eu de problèmes avec les récepteurs Corona.
Bind immediat avec XG8 sans même mettre le TX en mode binding. Il suffit de suivre la notice.
ATTENTION: chaque modèle a sa propre signature émetteur donc si vous changez de modèle, il faut refaire le bind du RX.
C'est parfait, je recommande.They're great receivers you have to check the way you plug the connectors. The ground goes facing the binding button if you reverse the polarity (the ground facing up the sticker) the red light will turn on but not going to bind i found this the main cause for people with binding concerns, the instructions says two ways to bind, one is specifically for the XG7 and the other way is for all transmitters including the JR XG series but not the XG7 hope this helps.Brilliant cost effective alternative to genuine JR receivers. I have 4 of these in various aircraft with my XG14 and they have been 100% reliable. Bit tricky to bind and you must follow the instructions EXACTLY. Don't use the JR transmitter bind option in system menu as there is no telemetry.bought two for my XG8, one wont power on and the other wont bind.. so cant say they are any good, awaiting refund/replacementbought two for my XG8, one wont power on and the other wont bind.. so cant say they are any good, awaiting refund/replacement