Dead Cat V1.5 Quadcopter Frame Kit w/Defibrillator Integrated PDB
Dead Cat V1.5 Quadcopter Frame Kit w/Defibrillator Integrated PDB
Awesome!
Copy and Share the Below URL
HobbyKing™ have pulled out the defibrillator and shocked life back into the Dead Cat frame kit! The Spider style quadcopter was already awesome with its optimized arm angle and layout for a propeller free FPV view. And now the much awaited progression to an integrated power / AV distribution board and plug in power shield.
The integrated PDB has direct soldering tabs for the motor ESC power lines at the base of the arms and input power tabs located directly above the battery to reduce the volume of wiring needed. There are power connector’s at the front, back and center for your FPV gear and flight controller which in turn are all linked to the power shield.
The Power shield effortlessly supply’s a regulated, filtered and RF noise shielded 5V at a whopping 3 amps for the camera and flight controller, and 12 volts at 1 amp for the hungriest of video transmitters.
The video connectors at the front and rear not only supply the voltage, but also carry the audio and video signal from the front mounted camera to the rear mounted video transmitter. This upgrade will save you weight, clean up your layout and improve reliability by reducing connection failures.
The glass fiber motor mounts provide 16 and 19mm bolt hole spacing meaning you can fit a multitude of brushless motors. The upper and lower deck's size means there is plenty of space for your preferred ESC's and flight controller etc.
Features:
• Integrated power distribution board
• Wick style solder tabs
• Camera and video transmitter integrated wiring
• 3~4 cell input
• SMPS converter with RF noise protection shield
• Thermal Protection
• Spider style frame design
• Propeller free FPV
• 28~35mm bolt hole spacing to accommodate a multitude of motor sizes
Specs:
Input Voltage: 8-16v (3-4 cell LiPoly)
Frame Weight: 482g
PDB Output: 5V/3A and 12V/1A
Motor Mount: 16, 19mm bolt hole spacing
Required:
4 x 28mm 1000~1200kv (or similar size/kv)
4 x 15~30 Amp ESC
4 x 8x4~10x4.5 Prop (2CW & 2CCW)
1 x Flight Control Board
1 x 2200~4000mAh 3~4s (11.1v ~ 14.8v) LiPoly battery
FPV gear (optional)
