Become a Supplier Blog New Items
Register

Total Price

$0.00

Cart 0 Cart 0 Loading...

Durafly™ Bravado - Precision 3D Aerobatic Sports Plane 1000mm (PNF)

Generating Links

Durafly™ Bravado - Precision 3D Aerobatic Sports Plane 1000mm (PNF)

Price:

Now save save $0.00 $0.00

$165.77
Already Purchased Discontinued Product

Please continue searching for a similar product.
SKU:
9095000027
want FREE shipping? Click here to find out more!

Show your Bravado!

Everyone loves a good 3D plane, but they've been rare in foam... until now. The Bravado is exceptionally well finished, equipped with an over spec'd brushless power system and designed from the ground up with 'LiteCore' EPO construction technology, the Bravado is sure to please.

Duraflys new 'LiteCore' construction is light weight yet high strength in a design that lends itself perfectly to the punishing demands of any serious 3D/aerobatic pilot. The Bravado's huge control surfaces and side areas coupled with the precision TG9d digital servos and brushless power system give the Bravado all that it needs to perform a huge range of aerobatic and 3D manoeuvres. The Bravado can perforrm Blenders, harriers, prop hanging, tail dragging and knife edges all day long, the Bravado welcomes them all.

The Plug and Fly (PnF) version of the Bravado comes with an over spec'd brushless system for unsurpassed power and performance. This is pre-installed, along with the Turnigy TG9d high torque digital servos and 40amp ESC. You'll just have to glue in the wings, hinges and hook up the control surfaces to a receiver, connect the battery and you're ready to tear up the sky!

If you are looking to show the world just how good you are at 3D flying or even if are just getting into it, go ahead and show them your Bravado. 

Features:
• Ultra fine surface finish and detail
• AirCore' EPO construction technology
• Tough EPO construction with extensive carbon reinforcement
• Precision Turnigy TG9d high torque digital servos
• Extra large surface area
• 3 cell set-up out of the box
• Pre-applied decals and paint finish
• High level of pre-assembly and minimal part count, assembly time less than 1 hour

Specification:
Wingspan: 1000mm ( 39.4 in.)
Motor: 2814 1000KV
ESC: 40 Amp
Servo: 4 x Turnigy TG9d 9g digital servo’s
Radio/Receiver: 4ch or greater Tx/Rx (required)
Battery: 3s 1000-1300mAh lipo 25c min (required)
Prop: 11" x 5.5"

Required:
Radio/Receiver: 4ch or greater Tx/Rx
Battery: 3s 1000-1300mah lipo 25c min

  • Durafly™ Bravado - Precision 3D Aerobatic Sports Plane 1000mm
Upload video

Only registered users can upload video. Please, log in or register

Topics
Sort by
Most Recent Topics
* Nickname:

* Your Reply:


Please, enter the text shown in the image into the field below
*Verification Code:
Cancel
Submit
Post a new Topic
* Nickname:

* Your Topic:



Please, enter the text shown in the image into the field below
*Verification Code:
Post Topic

Only registered users can write reviews. Please, sign in or sign up

qqqqqqqqqqq | Verified Buyer

  • Overall
  • Quality
  • Value

Customer Rated

May 26, 2016

Extremely low quality servos. Very low quality mounting. good foam. Please, mount by yourself. Replace servos: TG9d are incredible bad. ESC's brand seems to be a secret.

| Verified Buyer

  • Overall
  • Quality
  • Value

Certified Buyer Rated

May 25, 2016

This plane is wicked! Talk about extreme aerobatics! The huge surfaces make for and awesome day at the field! The color scheme and quality of this thing was impressive! Some people have complained about the servos, however I have had zero issues! They are responsive and have plenty of torque! Motor and ESC are more than enough for this thing. over all great plane, and can't beat the price!

Omegahombre | Verified Buyer

  • Overall
  • Quality
  • Value

Certified Buyer Rated

May 12, 2016

Great little plane fly's like it's on rails, also used 1800mah lips for extra duration.

__sipo | Verified Buyer

  • Overall
  • Quality
  • Value

Customer Rated

Dec 01, 2015

Perfect airplane but very poor servos. first servo was broken after one flight. Will replace all. Engine power is more than enough. CG is 115 mm measured from the front of the wing.

watdazit | Verified Buyer

  • Overall
  • Quality
  • Value

Customer Rated

Nov 09, 2015

I had some problems getting the COG right. For me the manual recommendation was way out. I ended up with the battery as far back as it will go and it balanced at 105mm. After a couple of flights I put 4g of lead on the tail as it was flying a bit nose heavy. This gave me a fairly neutral COG which I prefer. I was using a Turnigy 1300 3S battery at the back of the tray. There is only about 5mm to play with. Now I have the COG right I can see what it will do. I think it needs some lateral balancing. One other thing I put 50mm wheels on it but on my grass runway, which is a bit rough, it kept nosing over on take off and landing. I hand launch which it did easyily. I found I had to land with some power on as it was stalling in the air if I didn't.

Do not take any notice of my ratings. My fat fingers gave the wrong rating and I couldn't change them,in any case it is too early.

AMV94 | Verified Buyer

  • Overall
  • Quality
  • Value

Certified Buyer Rated

Nov 03, 2015

very fun plane but needs some reinforcements at the tail.

Gianpaolo | Verified Buyer

  • Overall
  • Quality
  • Value

Customer Rated

Nov 03, 2015

Fate molta attenzione, ho acquistato il modello e uno dei servi risultava sgranato.
ho chiesto la sostituzione del servo rotto , ma mi stato chiesto di inviare in Inghilterra il modello completo per una verifica.
Il costo per l' invio del materiale richiesta dal corriere , spesa di 48 euro , rimane a mio carico .
tutto per un servo da 3 ????
complimenti..
Pay close attention, I purchased the model and one of the servants appeared grainy.
I asked for the replacement of broken servant, but I was asked to send the complete model in England for examination.
The cost for the 'send the material requested by the carrier, spending 48, remains at my expense.
all for a servant from 3 ????
compliments...

Gianpaolo | Verified Buyer

  • Overall
  • Quality
  • Value

Customer Rated

Nov 03, 2015

Bel modello ma con difetti:
sono veramente deluso e arrabbiato .....
Servi deboli , aperta la scatola un servo risultava sgranato .
se fossi andato in volo avrei distrutto il modello , il servo danneggiato era quello dei comandi di profondit
Sono in attesa che mi contattino per il cambio del servo (SPERIAMO).
I'm really disappointed and angry .....
Servants weak, open the box a servant appeared grainy.
if I went to flight would have destroyed the model, the servant had damaged the command's depth
I am waiting for contacting me for the change of the servant (HOPE).

wmurray | Verified Buyer

  • Overall
  • Quality
  • Value

Customer Rated

Oct 26, 2015

First flight had some trim problems and landed a little hard. Landing gear folded and upon review I discovered that the plastic mount had fractured. I had to redesign the landing gear mount. Very POOR design with only some foam holding it in place. Also the tail wheel came off and didn't find it.
Hoping to get back out for a second effort soon.

jdef1 | Verified Buyer

  • Overall
  • Quality
  • Value

Customer Rated

Oct 06, 2015

This plane is totally over rated.. Cheap servos Rudder servo stripped on 2nd flight. Hovers Ok but knife not clean needs mixing Harrier weak stability weak.

  1. 1
  2. 2
Customer files
Bravado Manual Download [1516]
Bravado Manual Download [1516]
Bravado Manual Download [1516]
Bravado Manual Download [1516]
Upload your file

Only registered users can upload files.
Please log in or register to start helping your fellow hobbyists today!

Accessories