The Easy 3D is a great sized club aerobatic model of the traditional style that is designed to be great fun as well as cheap and easy to build.
The Easy 3D is lightweight but designed to handle a little abuse! For instance, the alloy under-carriage is uniquely rubber mounted, the steerable tail wheel uses a substantial rudder & fuselage mount, all three wheels use proper rubber tyres, the control horns are the heavy duty type and the cowl is of a tough GF construction. Also included with the Easy 3D is mounts for both glow and EP, fuel tank, engine mount and spinner, making it great value for money!
This great performing "club" aerobatic model is also cheap to build, standard servo's will be more than up to the job for all but the most hardcore 3D pilots and there is no doubting the capability of this nicely priced model, it's brilliant low speed performance combined with it's easy to fly nature make the Easy 3D a great first 3D model or on low rates, a great fun aerobatic model!
• Lightweight Balsa/Ply Construction
• Brightly coloured & Traditional See Through Covering, Great for Orientation
• Fast and Easy Build
• Rubber Mounted U/C
• Comprehensive Hardware Included
• Great First 3D Plane
• Mounts for Either Glow or EP
• Hard-wearing Rubber Tires All Round
• Plug In Wings for Easy Transportation
• Large, Quick Release Canopy
Wing Area: 45dm2
Your own 6 Channel TX/RX
0.46 Glow Engine/42mm Brushless Outrunner Motor around 800w (3D)
5 x Standard Servo (4 x for EP version)
60A ESC (EP Version)
RX Battery (Lipo or Nimh)
UBEC (for EP or Lipo RX Battery)
4s Lipo 2700mAh~3300mAh (EP Version)
Very good plane,stable,easy landing,capable for 3D.Flies without problems on a lower speed (not to low!).Takes a lipo 4S/4000 without any problem what does give a flying time from about 8 minutes.Motor SK3 4240 ,prop 14x8 wood.All right for H.K.Try again signed me out before I had posted.
Nice plane looks and feels well built.
If you want to run Glow then you need to cut the bolts down on the landing gear mounts inside to make enough room for the tank to fit in .
I have made mine Electric using a 1100w motor 4s 4000mah 40c lipo 100A opto esc sbec .
run motor on a 13x6 prop = 928w 80A should be plenty for my prop hanging 3D moves.
900watts is about the same as a .46 glow
Had to move battery back to get the c of g .
This plane is for 3D not for fast flying.
Once I get the time and weather to fly it I will give the resultsGood looking plane, great hardware. My only deduction is because I had to inject glue into the wing to secure some parts that were loose. I haven't assembled it yet but am getting ready. I have an OS .46 2 stroke to put on it. It should zoom.