ESCLinker v1.0
The ESCLinker v1.0 is used to load or update SimonK or BLHeli firmware on ESC’s. The multifunction tool is compatible with SimonK and BLHeli ESC (with or without Bootloader). It supports ISP and C2 Mode to flash new MCU (which hasn't installed Bootloader).mon
Features:
• Direct plug design, works with most USB port and USB Extension Cables
• Low power consumption
• On board 2x3 Pin AVR ISP port
• 3pin Servo connector, can be used as Servo or C2 connection
• Supports SiK and BLHeli ESCmon
• Software upgradeable (via Arduino or BLHELISUIT)
• Pre-Loaded with BLHelisuit 4w-if 14.1 firmware
Specs:
Size: 41.4 x 15.4mm
Weight: 3.5g
