Fatshark has introduced it's new 3-Axis pan, tilt and roll Camera Mount System to go along with their revolutionary 3-Axis Trinity head tracker. Utilizing a high speed metal gear base (pan) servo and 2 high speed tilt and roll servos, the mount matches the Trinity’s rapid motion capabilities perfectly. The System comes with 2 camera mounts, one for the fatshark 600tvl CMOS (20mm) and a second for 25mm cameras such as the new fatshark 420CCD V2.
*Note: This unit does not include the camera.
Nice resolution servos. With maxed throws (150 percent on a dee exx 8) you can really look around, in rudder axis close to 90 degrees, same with elevator axis. The roll axis is a little more limited but that's not going to be an issue. Servo centering was a little so and so, but they are not off by much. Weight 45.8gr for the main unit, add another 2.2gr for the extra camera mount and the two screws. Can't wait to try this with the Trinity head tracker! Recommend.It works great with my trinity board. Panning is about 180 degrees, so that's fine.
There's only 1 problem though:
It comes without a camera, but HobbyKing doesn't stock the recommended
Fatshark 600tvl CMOS camera. So stars faded for that.
I had to buy the camera from RC711 or RMRC.
HobbyKing: PLEASE STOCK THE Fatshark 600tvl CMOS camera.