70 percent of the earth's surface is covered in water. That means a virtually endless supply of prime flying sites that are completely un-tapped. What's that you say? My plane has these pesky wheels on them.
Hobby King to the rescue with a new set of floats perfect for your 40~60 size airplane. These all balsa/plywood floats come pre-built and covered with all the hardware needed for installation. No need to spend many hours laboring over the build, making sure they're waterproof, and finally installing them. We've cut out the first two, and most laborious steps.
These floats are perfect for installation on Cubs, Beavers, or really any other plane you want to fly off of water. The plastic film these floats are covered in waterproofs the wooden structure, plus has printed details like panel lines and rivets which really sets off any scale model.
• Fully built-up balsa and plywood construction
• Pre-covered with waterproof plastic film
• Printed scale panel line and rivet details
• Aluminum struts and all mounting hardware included
• Full installation instructions included
*Note* When sizing a airframe for floats, it is best to select an airframe where the float length is approximately 80% of the fuselage length.
Used these floats on a Tower Hobbies 80 inch cub with a power .46 electric. look great and worked great. Set them up carefully per directions and have not had to adjust them at all. Very pleased.Used these floats on a Tower Hobbies 80 inch cub with a power .46 electric. look great and worked great. Set them up carefully per directions and have not had to adjust them at all. Very pleased.