The FrSky Smart Port RPM and Temperature Sensor has been designed to work with FrSky Smart Port systems, it can measure the RPM of brushless motors from 1,000~30,000rpm and temperatures of -20 to 250 degrees celsius. Other FrSky Smart Port enabled sensors including the variometer, lipo voltage, GPS, current and airspeed sensors can be used at the same time.
Installing is easy, just connect the sensor to any 2 wires on the brushless motor by the supplied JST cable and then plug the smart port lead into the smart port enabled receiver. 2 temperature sensors are supplied which are plugged to the PCB so you can use a single one or both. Attach the temperature sensor to your ESC to enjoy the full benefit and peace of mind from this fantastic product. Set up is very straightforward using the push button and LED status indicator.
Please note: The FrSky Smart Port RPM/Temperature Sensor is only compatible with FrSky Smart Port enabled receivers such as the X8R, X6R and X4R.
• Measures RPM from 1,000~30,000rpm
• Measures temperature from -20~250°C
• Simple and easy to install
• Small and lightweight
• LED status indicator
• Easy push button set up
Operating Voltage: 4~10V
Voltage Range of Motor Wires: 2~12S (7.4~44.4V)
Measurement Range of RPM: 1,000~30,000
Measurement Range of Temperature Sensor: -20~250°C
Dimensions: 29 x 20 x 2mm
1 x FrSky Smart Port RPM and Temperature sensor
1 x Smart Port connector cable
1 x JST connector lead
2 x Temperature sensors
1 x Instruction manual (also see under "Files" tab for a copy of the manual)
i bought 2 of these the first one last only an hour , then the rpm was dead and one of the 2 temp sensor was showing -26 degrees and the other +21 ,,,,hummm , ok so i bought a second one this one is still working for now hoping its gonna last for a while , also i wish fr sky could put longer temp leads a the sensor , the leads are only 11.5 inches long, because if you want to use it on a hexacopter tarot 960 like a i do !,,,good luck , the esc`s on a tarot 960 is 14 inches away from the main frame, so the rpm sensor on my hexacopter is 2.5 inches outside the main frame which i don`t like !, this little electronic device gives me critical infos so i would prefer to keep it inside the frame , but for the price ,,,its a good device a must on a craft.very practical gadget for important informations about motors rpm and 2 temperature sensors which you can use battery and esc`s temperature monitoring , so i bought 2 rpm sensors to put on my hexacopter , the first one last only 1 hour then the rpm went dead ! and 1 temp sensor was showing - 26 degrees the other one was at + 21 ,,,humm ! ok , so i bought a second one , this one works for the moment hoping its gonna last a while !!The FrSky Smart Port RPM/Temperature Sensor is only compatible with FrSky Smart Port enabled receivers such as the X8R, X6R and X4R.Ya usaba los sensores frsky de la serie D, los antiguos, estos me parecen mucho mejores, mas comodos y funcionan muy bien, estoy muy contento con ellos, probe tambien un vario y estoy muy contento.