The H680 V3 is a well thought out 680mm hexacopter frame built from quality materials. The main frame is glass fiber while the arms are constructed from ultra durable polyamide nylon.
This version 3 of the H680 features integrated PCB connections for direct soldering of your ESCs. This eliminates the need for a power distribution board or messy multi-connectors, keeping your electronics layout very tidy. V3 also comes with stronger molded arms, so no more arm breakage at the motor mount on a hard landing.
Assembly is a breeze with pre-threaded brass sleeves for all of the frame bolts, so no lock-nuts are required. It utilizes one size of bolt for the entire build, making the hardware very easy to keep in order and only requiring one size of hex wrench to assemble.
The added lift capacity of a hex configuration makes this frame ideal for carrying larger payloads such as camera systems and other electronic components. This makes for an exceptional camera rig or simply a very agile and powerful multi-rotor frame.
The H680 also features colored arms (3 white and 3 red) which are great for orientation. It helps to keep you flying in the right direction without the need for different colored props.
We offer a full line of multi-rotor electronics such as multi-rotor control board, ESC & motors. It has never been easier or more affordable to get a hexacopter in the air!
• Built from quality glass fiber and polyamide nylon.
• Integrated PCB connections for direct soldering of your ESCs
• Pre-threaded brass sleeves for all of the frame bolts.
• Colored arms for orientation to keep you flying in the right direction.
• Mounting tabs on the main frame bottom plate for easy camera mounting.
• Ideal for carrying larger payloads such as camera systems and other electronic components.
• Easy assembly
Weight: 810g (Without electronics)
Motor Mount Bolt Holes: 16~19~25mm
6 x 35mm 600~900kv (or similar size/kv)
6 x 30A ESC (Recommend 30A OPTO)
1 x Multi-Rotor Control Board (Recommend KK2.15)
1 x 3000~4000mAh 3s 11.1v LiPoly battery
This turns out to be a really nice kit. It is large and well suited to the flat "pancake" motors. The arms are very rigid. Assembly is straight forward and quick. It will spin a 13" prop and has good lift capability. I fitted mine with retractable landing gear. I thought the gear was going to be sort of a fun gimmick, but I really like the looks and performance with the gear pulled up. It no longer looks like a bumblebee in flight and loses some of the yaw divergence induced by the low centered mass of a set of crab landing gear. It does need some sort of landing gear for most setups. Inexpensive (except for shipping). Recommended.Arm's are very durable. Arm's are partially compatible with TBS disco.
What I mean by partially is the screw holes are same so it will fit nicely without any modification but then the height of the arm is just too short so you need to have some sets of spacers to fill the gap and make it work.
One factor I didn't like was the package. The package box was unnecessarily and ridiculously big. This boosts up the shipping cost which was quite bad.