-
Product
Description -
Now you don't need to stop flying when the sun goes down!
With hexTronik's glow-wire system you can outfit your plane with unique, lightweight and colourful neon glow wire lighting, allowing you to fly all night.
The Glow-wire driver connects to any channel on your receiver and will drive two 1.3mtr long neon wires. The neon wires are flexible and can be moulded to any shape.
The driver weighs around 8grams and is extremely small. You can even connect several drivers to the one receiver for an unlimited number of lights and colour combinations.
The hexTronik glow-wire driver has been carefully designed to minimise noise and maximise the illumination with any given receiver voltage.
To use the glow wire system, simply plug the driver into a spare reciever channel and plug the glow wires into both ports on the driver*.The hexTronik Glow wire system is extremely easy to use and creates an exciting dimension to any R/C flight.
Glow wire sold separately.*Always connect both wires before powering the unit. Do not disconnect wires until power is removed from the unit. Running unit with only 1 glow-wire connected may cause the controlling chip to burn out.
Always change jumper to 6v if you're using a 6v power supply. Failure to do so will result in the chip burning out. -
Product
Specifications -
Additional Information
-
SKU:
GlowDriver-1
-
Brand:
No
-
Capacity (mAh)
No
-
Shipping Weight(g)
20.00
-
Length:
350.00
-
Width:
8.00
-
Height
19.00
-
SKU:
-
Community
Discussions -
-
Rate&
Review -
Small and light, plus it works! No real complaints. It's a little weak for some of the glow wire you can find, but it's advertised for 1.3 meter lengths specifically, so that's nothing against it. It's fairly quiet too, just in case you were making a costume or something to that effect.disgusting thing guys buy the unit and then have to buy the lights separate $2.99 plus $21.45 postage disgusting amount for a little thing which could be posted in an envelopeNo desconectar las 2 cargas sino falla los transistores y se quema la placaIt has separate modes for continuous ON and Blinking. Green wire seems to work well. Blue one is spotty with it.hi all,
i use it on my trex 450
work good but not enough light, it little bit darker and some times hard to see my t-rex.
you need fly at full dark place without any Lighting Page
Works well, small and lightweight chip for making models more visible in the night...leicht anzuschlieen und bersichtlich.very nice application for stiffen up the main wings on my F-15 EPO last 7 crash landings-1 time it bounced of the concrete sidewalk with this Epo foam-still in 1 piece-thanks HKIt's work very well... The only problem is when turn on 2 glow wire. So, the light is less than with 1 wire!i ordered 4 of it and it's perfect for night flys !!!
A lot of fun with.... -
Upload
Videos -
Upload
Files