HobbyKing XP 3A 1S 0.7g Brushless Speed ControllerThe HK 3A is a tiny (around 0.7gram) brushless speed controller built only for single cell applications and for current draw up to a maximum of 4A bursts.
This brushless esc is only to be used for Lipoly single cell applications where no more than 3A constant is needed.
High speed, Multifunctional MCU.
Full protection features Low voltage, Over-heat, Signal lost failsafe, Safe power On protection.
Supports 240,000RPM (2 poles) / 40,000RPM(12 poles)Programable by transmitter
Cont. Current: 3A
Burst Current: 4A
Max Voltage: 4.2v
BEC: Not required. power supplied directly from 1S battery.Programable: YesWeight: 0.7g
Please be careful when using this product. Due to its size and delicate nature it is easy to overload this ESC. Only use single cell Lithium Polymer batteries and never draw more than 3Amps or never more than 4A for more than 10 seconds.
this ESC is very good for its tiny size.....I have gotten about 20 flights now and it seems to be doing excellentthis ESC is very good for its tiny size.....I have gotten about 20 flights now and it seems to be doing excellentfantastic small ESCworks as it shouldthis works good in my small micro planescame quickly....looks just like what I want....will post again after doing some testingGut fr leichte Depron HallenfliegerVery good esc, this is the best 3amp esc out there, very fragile though so be careful! this esc's fets are fragile too, but for its size, its expected so don't push it more than its limits. but compared to other 3amp esc, this is the best so far.I have bought four of these units. One of them works. I am using the ar6400 brick. I followed the instructions, and there is nothing wrong with my wiring. my receiver is in brushless mode. Pretty sad.lger et idale pour gagner du poids sur vos micro indoor ....