HobbyKing™ EZ Master Trainer EPO 1230mm w/Motor (ARF)

• Overall
• Quality
• Value

Customer Rated

Apr 24, 2016

a very nice......piece of ch...... !
a real pain to install the front steering due to the drilling to clamp the wheel axle
and then i flew it about 20 seconds, made a flip, and the plastic stuff where you put the wing it went off due to lack of glue or bad glue i don't know, with the following result:

https://youtu.be/AoiX4hEVy4s

even my expensive upgrade emax 2215/20 motor is bent

gutted

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 01, 2014

I've just started putting mine together and have found some point's of interest, the main wing spar is only 30cm long and 6mm wide, the recess in each wing is 30cm, so they put a ridge in the centre of the 30cm spar to stop it sliding into either wing to far and causing the wing to fold, I would recommend adding your own spar at 60cm long, the wings themselves look very tough at least 3cm thick till near the wing tip, ..............The front wheel holder is a brass insert into plastic which connects to the push rod, I recommend removing the brass insert and CA gluing it back in, (very fiddly) the plastic moulding around the brass insert securing screw is less than half a mm! at 2 points around the securing screw, mine came apart just tightening up the securing screw, easy fix,... Oh and the kit came with 2 propellers even though the description says they are required, In general this looks like a tough plane, the landing gear looks good, all over I reckon it's a good trainer/slow flyer, I will report back after I have flown it, looks like a good purchase to me!