The HK Mi Series servos represent the next break through in high precision servo technology. Using Magnetic Induction, rather than a potentiometer, for an unsurpassed level of accuracy and performance.
Voltage: 6.0v / 7.4v
Speed: 0.14sec/60deg (6.0v) - 0.12sec/60deg (7.4v)
Torque: 20.0kg.cm (6.0v) - 23.0kg.cm (7.4v)
Size: 40.1mm x 20.5mm x 39.4mm
Gear Train: Full Titanium Alloy
Spline Count: 25
Mi : Magnetic Induction, uses a Magnetic Rotary Encoder in place of a traditional potentiometer (invented in 1877). Magnetic Rotary encoders have a longer life and suffer less wear.
Unit Weight (g):
Nutze das Servo in meinem Thunder Tiger e-MTA, da das originale zu langsam war und zu wenig Kraft hatte.
Bin sehr Zufrieden, macht einen wertigen Eindruck und auch die Werte fr Kraft und Geschwindigkeit stimmen.
1:5-s autba vettem egy haveromnak. Remlem bevlik neki....Be carefull! the gears of this servo are weak. It can't pass 20kg/cm under 6volt!
I don't recommend.I used it only 2 times on Savage XL on a dirt track, and the model is no longer steer, very poor gear, there is no titanium and there was not, see for yourself
http://s019.radikal.ru/i631/1401/01/15bab862cf79.jpgCentering was ok, but one out of five had its gear stripped during testing. I didn't measure torque, but obviously it is too much for the weak gears.I purchased one of these to use as a rudder servo in a 1850mm SBACH 342 with a DLE 30. I liked it so much I bought 4 more for the same purpose. Speed, torque, no jitter and very little slop in the gears. I'd use these on any surface of an aircraft up to 100cc except 2 on the rudder at that size.i'm using for my revo 1/10 single servo.very strong and fast at 7,2vVery bad quality servo, the gears stripped just after i plug it on !!! WTF
So i plug an old SAVX servo to replace and it work just fine !!
Don't buy this waste of money so now i am going to ask a refun from HK going to be long and hard i think ...Quickly stripped Titanium alloy gears,
No direct replacements available, however used some others that are available from this site, note this changes the torque specs for the servo.Good servos for it's price.
Bought 4, one have some lost motion and another one overheating while 9v reciever BEC. So now I have 3 good servos and one for backup.