Similar in size to 30 ~ 46 class engine powered helicopter. (flying weight 1950g)
Equiped with 1000W(KV850) external brushless motor , 50A(25V) ESC with Heat Radiator are included in kit.
High power to weight ratio (513 W / KG) gives excellent 3D capability, Belt driven tail rotor.
The cheapest battery cost.( 2 packs 3S1P in series, even your stock batteries for 450 EP heli work fine)
Multi-stage gear reduction system results in a streamline cabin and canopy.
Push-pull linkages on CCPM mechanism limits any play for sharp control response.
Dupont plastic and fiberglass composite main frame.
Precision CNC anodized aluminum swash plate, seesaw head with bell-hiller system.
Fully equipped ball bearings.(43 bearings)
Only a short time needed for completion. (90% factory assembled)
Extensive CNC upgrade parts and option parts available.
Overall length: 1060mm (including cabin & canopy)
Main rotor diameter: 1110~1210mm
Main blade length: 500~550mm
Tail rotor diameter: 222mm
Flybar paddle: 84*45*6mm
Tail blade length: 80mm
Overall height: 305 mm
Overall width: 85 mm
Motor: 1000w/kv850 external brushless motor (included)
ESC: 50A/25V ESC with Heat Radiator (included)
Flying weight: 1950g (It may vary according to size of a battery pack and R/C gears.)
Main rotor blades: wooden(included) or fiber(option)
Flying duration: 6~8 minutes with 11.1v/2200mah Li-Po battery 2 packs in series(22.2v)
Items needed for assembly:
6 (or more) channel heli-capable transmitter (with CCPM function)
4 servos (digital servo is recommended)
6 (or more) channel receiver
BEC : External BEC or Battery for receiver.
Gyro ( GU - 210 heading hold gyro or gyro with higher level are recommended)
Battery : Li-Po battery 3S1P (11.1v / 20C equal or over / 2000mah equal or over)*2 packs in series or 6S1P (22.2v/ 20C equal or over / 2000mah equal or over)*1 pack
Charger: Li-Po battery charger
Bought one of these 2 years ago from another vendor. Great heli, very stable good for a novice and handles wind much better than 450 size helis. Gaui ESC handles very high current (I have had mine to 70A) with no problems and soft start up is very good. Gaui motor is an amp hog, changed mine for a Z20, much lower amp draw and slightly more power. If you want extreme 3D go for Z30 motor. Hope you soon stock all the parts, I need a few.i want to buy...but my cosy is't enough...nexx latter