The AC810 by KS-Servo is an 8 channel FRSKY compatible receiver that is small, lightweight and very affordable.
Pefect for smaller models where keeping the flying weight down is critical, this unit only weighs 4.9g.
• Compatible with FRSKY ACCST
• Compatible with X9D(Plus)DJT/DFT/DHT
• Small and light weight
Number of channels: 8
Range: Approx 800m
Dimensions: 23 x 30mm
8 Channel Receiver
j'en avais commandé un premier qui est arrivé sans pin centrale sur la voie 8.
il s'est bindé quand même,mais plus de signal à 50m et non pas à 800m.
après réclamation j'en ai reçu un deuxième en échange,mais avec exactement le même problème,pas de pin centrale sur la voie 8,à croire que toute la série est défectueuse.
j'abandonne je demande le remboursement....désastreux,j'en ai commandé un premier qui est arrivé sans pin central sur la voie 8
test de portée 50m au lieu de 800
j'ai fait une réclamation j'en ai reçu un deuxième en remplacement ce matin avec le même problème,pas de pin centrale sur la voie 8.
je demande le remboursement.....fonctionne bien avec ma 9xrpro ,idéal pour les parkflyers
bon produitGood receiver for my FRSKY TARANIS PLUS radio (X9D+) and to fly foamies or parkflyers.
it includes the notice with good explanation about binding !
Binds immediatly with X9D+ as exposed in notice, in D8 mode.
I recommand to set the TX to 8 channels even if you don't use all of them elsewher may hapen lost of radio.
Also think that failsafe is only on channel 3. That is a problem if as I do, you fly in Spektrum mode, with motor on ch1 !!!Worked with my DJT module on my 9XR Pro by using the following instruction on rc groups
https://www.rcgroups.com/forums/showpost.php?p=35693607&postcount=3069Got first one. Transmitter is a DJT. Binding like Midelic described on https://www.rcgroups.com/forums/showpost.php?p=35693607&postcount=3069 and all I could get was small bursts of control. Allso the board looked corroded. After a LOT of tries, I finally gave up. HK send me a replacement. Same thing. Tested with new FW FrskyRx_F801_TELEMETRY_PFS_SBUS_071016.hex and it has worked! Flashed the old one and it has worked also.I bought this receiver and also an AC410. Neither will bind to my Taranis. I am not a newbie and do know how to bind them. Both Receivers got too hot to touch. All polarities were correct. D8 mode selected. I think I have wasted my money.Good receiver, Just keep in mind that the failsafe es pre set to CH3 cut, always connect your motor to CH3This receiver is a very bad product! It binded without problem with my Taranis. But the next time I tried to use it, there was no reaction and the components were so burning hot that I could not hold the receiver in the palm of my hand. Obviously poor QC and/or low grade components. Save you money and buy a hardly more expensive real FRSky product. This one is just good enough for the recycle bin :(I have now checked three of these receivers and all react in the same way to loss of radio signal - after initialising throttle down and rudder neutral then channels 3 and 4 both go to 2000 mS ie full swing meaning for most set ups the Motor goes full speed and the rudder hard over!!! Seems to indicate bad firmware to cause this very DANGEROUS situation that could cause both model and personal injury.
This has been reported to HK several days ago.