Matek Mini Power Hub w/BEC (5V and 12V)
The Mini Power Hub has been engineered to provide the highest possible performance and reliability in a 36*36mm and 4 layer PCB. The Hub distributes power from a battery pack to 4 ESCs, as well as, providing synchronized and regulated DC outputs for powering camera’s, servos, video transmitters, LEDs, etc. Batteries may range from 3S to 6S LiPoly. The hub also features convenient solder bridge of various voltage for camera and video TX.
This Power Distribution Board makes a great addition to your multi-rotor.
• 2oz copper and 4 layer PCB
• ESC and battery solder tabs in pairs
• Solder bridge of various voltage for Camera and VTX
• Regulated 5V and 12V with output LED indicators
• Short circuit tolerant (10sec/min)
Input Voltage: 9~26VDC (3S~6S LiPoly)
ESC outputs continuous current: 20A per output
ESC outputs peak current (10secs/min): 25A per output
BEC 5V output: Designed for RC Receivers, Flight controllers, OSD and Servos
BEC 5V output: DC/DC synchronous buck regulator, efficiency is up to 95%
BEC 5V output voltage: 5.0 +/- 0.1VDC
BEC 5V output continuous current: 3A
BEC 12V output: The battery should be 4S~6S LiPoly
BEC 12V output: Standard output designed to power cameras and video transmitters, etc
BEC 12V output voltage: 12.0 +/- 0.2VDC
BEC 12V output continuous current: 2A (max 3A 10sec/min)
Dimensions: 36 x 36mm
Mounting holes: 30.5mm square spacing
The output of the 5v bec is 6 volts and the 12v bec outputs 14 volts on a 4s Lipo. The same board from another shop does output the correct voltages. But this was by far not the worst thing about the board.
At first everything seemed fine with the board. No short circuits. Quad was flying great. Then the whole of the board turned into ONE BIG SHORT CIRCUIT!!!! Resulting in magic smoke out of motors and esc's. (luckily refunded)
Very nice power hub. Provides 5 v for my FC ,camera and receiver & 12 v for video transmitter and an LED strip. Holds 20 - 25 A without any problem.