The Mercury is a lightweight and agile high performance 3D plane that will push your skills to the limits! Reinforced with carbon fiber, the Mercury is designed for ultimate 3D and beyond! The light wing loading, combined with massively oversized control surfaces makes this the ultimate indoor 3D/F3P airplane. The vibrant color scheme looks great in the air and on the ground.
The airframe is of all 3mm foam construction with carbon fiber rods reinforcing the fuselage and wing sections. The carbon leading edge keeps the wing stiff, and also protects it from damage if you fly into anything. To keep flex to a minimum, and precision to the max, the ailerons on the Mercury are fully reinforced with carbon struts that pass through a wing fence. This is kit only allowing you to install your choice of electronics and battery to get the Mercury flying.
The Mercury is a full kit and requires about 4~6 hours to complete.
• Kit - Build to suit your preferences and install your choice of electronics
• 3mm Depron foam airframe with carbon fiber reinforcement
• Ultra-light weight landing gear and wheels
• Vibrant multi-color printed graphics
Flying Weight: 186g
4+ Channel transmitter and micro receiver
3 x 7~9g servos
2204 1700kv brushless motor
10amp brushless ESC
2S 7.4V 500mAh lipoly battery
8x4 GWS propeller
Foam safe glue
High manufacturing quality easy to built
Kit de grande qualit de fabrication
Facile monterVerpackungsgewicht 634g Verpackungsabmessung 87x28,5x2,5cm
sehr schoen ausgeschnitten, schoenes Finisch, Servos kann man leichtere auch nehmen, sehr gute Carbonverstrebungen, empfehlenswetes Modelli have 2 of these. the only problem i have had is the push rods can get stuck on the mounts and the carbon rods are not cut to size but other than that they are great fun and easy to set upGreat plane if your new to 3d foamy's. I used a hot glue gun instead of ca glue. it took me just over 4 hours to get it all together and as i use a hot glue gun i was able to fly as soon as i was done. the only negative things i would say are the carbon rods are not pre cut, and the 45 degree angle's on the control surface's are not pre cut. but for the price you cant complain.just flew the mercury its nuts...unreal kit..everything was A1..flyes very light. im running axi 2204/54 with 8/3.8 apc with a turnigy 3cell 850 mah for a bit more orthority. i fly it mostly out side on calm days but a bit of a breeze is good for hovering n axle rolling on the spot lol