The Micro Storm 32-s 3 Axis BGC is a high quality DIY brushless gimbal controller that offers unparalleled professional stabilization properties at 32Bit level. The Micro Storm 32-s board also features an integrated HC06 Blue tooth unit which allows you to program the board wirelessly without any cable connections.
The Micro Storm 32-s has a 32Bit microprocessor which operates at 72MHz and provides sufficient power to your DIY gimbal assembly. The 32Bit microprocessor and firmware combined provides an incredible range of programming functions.
The on board output options provide a multitude of connectivity options including PWM, PPM, IR LEDs, joystick, button, 7 x auxiliary ports which can be used as inputs and/or outputs for PWM/Sum-PPM signals. The Storm 32 also supports the connection of a range of satellite receivers including Futaba S-Bus and Spektrum types.
• Processor: STM32F103RC at 72Mhz
• Motor driver: DRV8313 with short circuit, overheat protection
• On board gyro and acceleration sensor MPU6050
• IR LED Interface
• Futaba S-BUS Compatible / Spektrum satellite port
• 7CH PWM/Sum-PPM input/output
Power Supply: 12v (3S)
Drive Current: Max 1.5A
Mount Holes: M3
1 x Brushless controller
1 x MPU6050 sensor
1 x Sensor connecting cable
- Blade Count:
From the STorM32 Wiki: "This board is suitable only for 2S (see []), with higher voltages it gets quite hot and may malfunction. Read also this: []. The board can only be flashed with a ST-Link adapter via SWD, it cannot be flashed via the "usual" procedure. Many pins/ports are not available. Overall, this board cannot be recommended, except for special applications."
Note: "cannot be recommended" - they don't tell you this in the description!
Good Quality but it needs better instructions like what GUI to use. Also Lots if IC2 Errors and interference, but over all good product!