Shipping options for this item may be limited from the international warehouse due to postal service limitations. This item is stocked in a regional warehouse near you.
Want to dramatically increase your multi-rotor flight times without the penalty of added weight? We have just the solution!
The all new Multistar high capacity batteries are the result of extensive testing and development with one goal in mind...increasing flight times for your multi-rotor aircraft without the penalty of added weight.
We have achieved our goal by drastically increasing the battery capacity (mAh) while lowering the discharge rate. This results in a battery which is still capable of providing sufficient current (Amps) while offering much higher capacity when compared to a standard 20C+ LiPoly battery of the same weight.
What this all means is that Multistar batteries are able to provide flight times much longer than standard LiPoly battery packs without adding any weight to your multi-rotor model, making them absolutely ideal for use with aerial video and FPV multi-rotor aircraft.
We have a full range of Multistar High Capacity Multi-Rotor battery packs in the works and will be adding new sizes/configurations as they become available. Be sure to checkout the product video for more in-depth info about these all new high capacity multi-rotor battery packs.
• Ultra high capacity LiPoly batteries designed specifically for multi-rotor use
• Similar size/weight as batteries of much lower capacity, making these a direct drop-in upgrade for most multi-rotor aircraft
• Provides increased flight times of up to 20% or more when compared to standard LiPoly batteries of the same weight
• Ideal for use with aerial video and FPV multi-rotor aircract
Minimum Capacity: 20000mAh
Configuration: 6S1P / 22.2V / 6Cell
Constant Discharge: 10C
Peak Discharge (10sec): 20C
Pack Weight: 2405g
Pack Size: 200 x 90 x 60mm
Charge Plug: JST-XH
Discharge Plug: XT90
Unit Weight (g)
Max Charge Rate(C):
I bought two of these for a bike battery. Much quicker and easier than welding a bunch of 18650's together. These perform really well and the price for energy density is awesome.
My bike's controller can push 40A so I can't tell you for certain how well these work at higher current draw then that but at 40A the voltage sag is 1.2V, this leads me to believe that these probably shouldn't be used at 10C as I imagine the sag would be worse, but I can't say that for sure.
I did a discharge test on these and they are indeed 20000mAh. I may buy more of these in the future and create a backup battery for my bike.
For my uses, this is a 5/5 in every category.I am very successfully using two of these batteries on an electric mountain-bike. One of the batteries that I first purchased had 2 faulty cells. This battery was replaced under warrantee.
I have just completed an epic single track mountain-bike trip over 50 miles with 6000 ft of climbing with battery to spare. When tested before and after, the battery cells remained within a few mV of each other and cell capacity was over 20Ah = very impressive.
The lowish "C" rating is not an issue of this battery is not an issue for eBikes.This Batt is Average at best!!!!!! Tarot x6 18.5 carbon propsafter 9 min,down to 21.6. volts. after unpluging, within 2 min,voltage back up to 24 voltsVOLTAGE SAG!!!! I will admit-this was 45 degrees out side. Bottom line OK!!!! Im sure it will be better in summer months. For the Value aspect-YES i would buy again.Excellent battery, 25 miles range on an electric bike with two of these. Good internal resistance and low voltage sag. However they are not good for 10C discharge, there is voltage sag and heat.