The IIc OLED is used for telemetry and debug of MultiWii Mini or any MWC FC with I2C, and with its high contrast ratio and super bright screen viewing data in direct sunlight is no problem. This OLED has a match cable and connector to plug directly into the MINI MWC as well as matched mounting holes so attaching it to the top of the MINI MWC is a direct fit. There are two I2C ports on the bottom allowing for dual connection to the I2C port.
Just some of the functions viewable on the OLED are: status display, MWC firmware version, aircraft mode, unlock status, remote input signal value, The FC output signal value, Gyroscope and acceleration status, Signal period / I2C error, voltage and current (if your MWC has the voltage and current sensor). In programming mode can display and assist to set the parameters, AUX switch function settings, PID parameter adjustment, Accelerator softness / curve adjustment and you even can make and display your own logo, the list goes on.
• High brightness, self-emission, high contrast ratio
• Monochrome 128×64 dot
• 3.3V~5V I2C interface
• Used for telemetry and debug MultiWii FC.
Weight: 3.1g/4.2g (include cable)
IIC OLED Display Module x 1
4Pin cable 40mm x1
NICE DISPLAY. AFTER A QUICK MOD WORKS WITH CLEANFLIGHT.Works fine with my MultiWii Pro board after adding 2 commands to LCD.cpp to enable the charge pump: i2c_OLED_send_cmd(0x8D); i2c_OLED_send_cmd(0x14);Pretty tiny oled Display, but works well.Clear displaying - easy to install - great pass through option - still waiting for the JST 1,25 connectors here in shop