NANO N32-Plus Flight Control Board
The NANO N32-Plus is a next generation Naze32 compatible flight control board but much much smaller in size! This tiny flight controller comes with a powerful 32bit processor. The N32-Plus comes in a handy size of just (28x22mm) that it will fit on the smaller frames with ease. For setup and configuration the USB break out board has been seperated from the main board to reduce the overall footprint, making this a very tiny flight controller with all the functions of a full size board.
The NANO N32-Plus comes with Baseflight firmware v1.90 and contains a barometer and magnometer which gives your flight controller excellent tuning and setup options.
Get this little beauty and get your quad flying!!
• Modern 32-bit controller
• Baseflight Firmware pre installed
• Tiny size
Firmware: Baseflight v1.90
NANO 32+ FCB
6pin header pack
RC Input Cable
PWM Output Cable
TTL-USB Board Cable
Beep & Bat Port Cable
You can only use Baseflight which is horrible. However, you can flash Clean or Betaflight, if you jump two super micro leads on the main chip. Somewhat difficult to do without touching other leads, but doable. I would have giving this five stars if the board had actual boot pads. Maybe the manufacturer can include them on newer versions.Is it possible to use "NANO N32-Plus Flight Control Board (Naze32 Compatible)" with 1S Lipo?Somebody help me, how can i flash this nano n32+ ? i try any times and no success.Somebody help me, how can i flash this nano n32+ ? i try any times and no sucess.Somobody help me, how can i flash this nano n32+ ? i try any times and no sucess.Nice little flight controller, dead easy to fit inside smaller frames. Everything works as it should, but I have taken off one star as mine was back feeding power into my ESC's bec when connected to USB. Not sure if this is common to all of these boards or if I just got a dodgy one. 10 minute fix by fitting a diode in front of the fc. Despite this I would happily buy another one.small very small finding a manual was a pain but once i did works greatIt is really mini!
Comes with cleanflight 1.9.0 and updated it to 1.11.0 with no hassle.
Seems to work fine , barometer also!
This will go to my KingKong 188 frame.
Can't wait to test it.This flight controller satisfies your needs and then some, and it will fit on any model thanks to its "NANO" size. It's really easy to set up with Cleanflight Configuration thanks to the usb extension. Great idea on making that seperate from the flight controller. Just a little soldering and your ready to program your quad! Thank's again HobbyKing!
10DOF download now [441kb] 10DOF download now [441kb] Board download now [86kb] boot loader pins (other side of board) download now [483kb] boot loader pins (other side of board) download now [483kb] bootloader download now [483kb] bootloader download now [370kb] Driver for external usb connector download now [333kb] driver-name download now [280.14Kb]