The new Pixracer is the first autopilot of the new FMU V4 Pixhawk generation! It comes with an upgraded Invensense sensor, a plug in Wifi board and a micro SD card and reader.
Like all Pix Autopilot/Flight controllers, this is a genuine open source project that is supported by the Arducopter and PX4 community. It runs PX4 software, QGround Control as well as Arducopter/Mission Planner.
Specs:
Dimensions: 36 x 36mm with 30.5 x 30.5mm hole grid with 3.2mm mounting holes
Weight: 26g
FRAM: FM25V02-G
LDO: Ultra low noise LDOs for sensors and FMU
Sensors: MPU9250 , ICM20608 , Baro MS5611, mag HMC5983
Connections: GPS+I2C, RC-IN, PPM-IN, RSSI, SBus-IN, Spektrum-IN, USART3 ( TxD, RxD, CTS, RTS ), USART2 ( TxD, RxD, CTS, RTS ), FRSky-IN, - FRSky-OUT, CAN, USART8 ( TxD, RxD ), ESP8266 ( full set ), SERVO1-SERVO6, USART7 ( TxD, RxD ), JTAG ( SWDIO, SWCLK ), POWER-BRICK ( - VDD, Voltage, Current, GND ), BUZZER-LED_BUTTON
MicroSD card reader: Yes
RGB LED: Yes
USB: Micro USB
WiFi: WiFi ESP8266 802.11bgn
Connectors: JST GH series connectors
Power supply: 5-5.5VDC from USB or Power Brick connector.
Includes:
Pixracer V1.0 Flight Controller
CNC Case (black, golden, red, blue selectable)
Safety switch + buzzer
Power Module Cable
Serial Cable
I2C Cable
Receiver Cable
WiFi ESP8266 Module
Micro SD Card + Reader
Design Credits and project details can be found here
https://pixhawk.org/modules/pixracer
https://creativecommons.org/licenses/by-sa/3.0/




















































































































































































