NTM Prop Drive motors are rock-solid performance outrunners with tight windings, quality bearings, correctly rated magnets, balanced stator and flux rings plus they are QC checked at 14 points, from material processing all the way through to final dyno test.
Because we design and build these motors completely in-house (from 3D/2D drawing to materials sourcing, machining, balancing, final assembly and dyno) we can completely control production and ensure product consistency from design right through to shipping the product to you. The removal of middle-men has meant we can drive better value to the market and retail these motors at factory(our) prices! All performance figures are real and tested on our own motor dynos.
Our QC engineers check and balance each motor before shipping to the HobbyKing.com warehouse.
Model: NTM Prop Drive Series 2826 1100kv
Motor Wind: 17T
Max current: 20A
Max Power: 189W @ 11.1V (3S) / 290W @ 15V (4S)
Cell count: 3s~4s Lipoly
Bolt holes: 16mm & 19mm
Bolt thread: M3
Connection: 3.5mm Bullet-connector
Motor Shaft: 3mm
Prop Tests :
8x4 - 11.1V / 100W / 9.1A/ 0.54kg thrust
8x4 - 14.8V / 116W / 14A / 0.82kg thrust
9x6 - 11.1V / 149W / 13.6A / 0.73kg thrust
9x6 - 14.8V / 285W / 19.6A / 1.05kg thrust
Note: An accessory pack is available for this motor. Please see the related items below.
Max Currents (A)
Length B (mm):
Can Length D(mm)
Unit Weight (g):
Total Length E(mm)
A good performer although have developed bearing movement after only a few flights but doesn't appear to affect operation. Also check grub screw securing shaft as mine was loose. Refit with a small drop of loctiteGreat motors! no problems getting them working. Dont forget the accessoriesWorks according to specs. Mine had a cold solder joint on one motor wire which detached (luckily while plane was on the ground after first flight).nice turn not only 8 turnExcellent drive for my e-Howk glider. It is 600 g and goes vertically to the sky. With 950 mAh nano LiPo, 20A ESC and 10" folding prop runs about 3 min giving flying time over 35 min. No vibration, no overheating, just like you expect from the good drive.HobbyKing please do something with bearings for this size NTM motors!!!!
Me and my comrade got this size motors(1000kv had problems too) with noisy bearings!
otherwise powerful motors of this sizeAfter less than 2 hours of use, the bearings went out on 1 out of 4 of these motors that I purchased at the same time. The price is excellent, so I would still recommend this motor, as the other 3 motors have very little play, and seem like they will last much longer. It is worth it to me for the cheaper price.perfect motor perfgect price enough power for any starter in rcperfect for quadcopter F450.
tested with esc multistar 20-30ampFantastic item, I use it all the time in all places and electronics. Nice n shiny finish, good covering