Compatible with all DSM2 Air transmitters.
The new range of OrangeRx R910 receivers are built using original components and MCU's and with state of the art SMT automation to ensure a quality product each and every time.
All OrangeRx receivers are QC tested before leaving the factory.
The OrangeRx will work with ANY DSM2 compatible 2.4Ghz transmitter.
The OrangeRx 9ch is only 14g in weight and 46x30x14mm in size with case, Great for medium/small planes & heli's, right up to large scale models.
Super light weight 14g grams with case.
Compatible with DSM2 1024/2048 aircraft radio and module systems.
9 Channels Analog & Digital servo
Compact design 38mm x 26mm x 9mm, with case 46 x 30.7 x 14mm.
Single 195mm antenna for mounting in almost any location.
Input voltage: 3.7~9.6V.
2 x Satellite port included. TWIN SATELLITE PORTS
1 Port S.BUS OUT - Works with S.BUS servos and GY750.
Failsafe: All channels to bind position at signal loss.
12 Month replacement guarantee!
OrangeRx R910 DSM2 Compatible receiver
1) This is not a Spektrum DSM2 product, nor is it a copy of a Spektrum DSM2 product.
The Spektrum and DSM2 brand is a trademark of Horizon Hobbies USA.
2) This is not an underground black market fake Spektrum product. OrangeRx quality is guaranteed.
3) Accepted by the MAAA in Australia, see the MAAA MOP58 for guidance
Visit www.orangerx.com for news and updates on OrangeRx products.
so far, so good. make use of the the two satellite ports on the side, better signal. Thanks HKThis is the third 9 channel orange receiver that I have had and I can not get any of them to work right. They bind ok, but thats about all. can't get the throttle to work on the last one. Finally used my Fataba fasst.Nice reciver for the price..works great with spektrum..i almost only use orange recivers in my planes todayfonctionne trs bien sur les 9 voies comme ceux achet auparavant.
recommended full range receiver for spektrum (DSMX or DSM2 use) particularly favorable and always working without failure,producto excelente justo lo que necesitabaPlease tell me what can I do if this new R910 Rx with 2 satt has the LED flashing only at half the intensity and only at the main rx and doesn't see the Tx. They both are DSM 2, tryed several accu even 6,6v Life. I've managed to bind it the first time. had an old 4,8v pack in it and connect 3 electric small retracts in ch5, actionated them several times untill all sistem whent dead , I think it ran out of current. Since then I can't make it work and stay working. Sometimes only the main has the led flashing, sometimes more bright, other times half of that. I might have brought it in safe mode by pulling the bind plug out first but how I bring it out of that? Sometimes it works, then if I want to bind it on another memory(plane) only the rx led is bearly flashing and doesn't see the tx.Thank youGreat stuff. Why to pay 50 for Spektrum AR8000 when this is 9 channels for around 14?!!!Works fine, good little light for telling you the status. Works great with my Naze32Tolles Teil! Die Reichweite war nach einem Kilometer immer noch nicht abgerissen. Bin begeistert