The Quanum QM12V5A-UBEC is an advanced switching regulator that will supply 5-8 amps of power for your servos and accessories. The UBEC has an input range of 7.2-25.2v (2-6 cell Lipo) and has a switchable voltage output (7.2V/12V). The UBEC also features an inline noise reduction filter and dual output connectivity, which allows you to power servos and additional accessories independently!
• 5A power output (8A Bursts)
• Switchable voltage output (7.2/12V)
• Dual output connectivity
• In-line noise reduction filter
Output: 5A continuous, 8A burst rate
Input: 7.2v - 25.2v (2-6s Lipo)
Size: 55 x 28 x 10mm
* To enable 12V output, input voltage source need to be at least 12V.
I bought this to run some leds and my fpv system, all good so far. It feels like good quality aswell.The negative input led is bridged to the capacitor right next to it. Is yours the same?Have used many of these before, always output nice clean power and have never had a problem with them in an enclosed space (not much airflow)accesorio indispensableWorked for a couple of flights then blew up 4 servoes and a receiver. I checked output and it's now 20.4 Volts in both switch positions. So this cost me 160 in damaged gear. Thanks!Konnte ich noch nicht wirklich ausprobieren , aber macht einen Stabilen eindruck und wirkt sehr gut verarbeitet !good qulity, good brand, nice buildGreat BEC but would be nice if both outputs could be set to 7.2V.These are great for powering your 12 volt lights, and other 12 volt electronics, from a bigger battery than a 3s.....like a 4s, like I use on my hexacopter.This Quanum Ubec works really well with my FPV! Two outputs and an extra fibre board over the components which makes it more robust and stackable.