This is a self-adhesive, super grippy non-slip pad that can be cut to size for use with just about any application. Its high grip surface helps to keep your battery pack from moving around in your helicopter, airplane, car or boat battery compartment. Also great for keeping electronics in place.
It is a good addition for the battery mounting, stick well to the plane, the anti-slip property is, well, not so great, but is making the job finally.It works! great in combination with fluorescent stripThis stuff helps keep your battery from sliding around, kinda. I was expecting the really rubbery/sticky stuff you put under carpet on a hard floor. Instead I found it to be harder and slicker than I expected which limits it's utility. On the plus side, it's very easily cut and sticks well on the inside of the plane.The strap is super. No more battery slipped. Recommended!Great. But dust make it not so non-slip.It does the job. I thought It is made of rubber or a more sticky material but it is something more rigid... anyway, when you place the battery on top and hold them tight with the strap, works well.Battery doesn't really grip to it.
Sorry hk :-)Absolute rubbish! This is the complete opposite of grip, its almost slippery and the batteries slide around on top of it easily. Avoid this product and get the silicone matt with double sided tape instead.Non-slip? A wet towel are more non-slip than this product! Totally useless!
If I put the non-sticker side on a glossy book or a table and start lifting one end it will slide of at 30-40 degrees!Great product for battery mounting. Slippery battery wrapping and carbon fiber equals shifting. This will keep it locked in. The low profile is great, doesn't take up much room at all. Putting it on every craft I have. Cheap too!