SK450 Dead Cat "Defibrillator" Power and A/V Distribution Board (Without) Power Shield

We pulled out the defibrillator and shocked some serious life it to the Dead Cat conversion! The Spider style Quad-Copter was already awesome with its optimized arm angle and layout for a propeller free FPV view. And now the much awaited progression to an integrated power and A/V distribution board and plug in power shielded (optional).

This is a great option for those who want the “Defibrillator” with integrated power distribution but don’t necessarily need the power shield for regulated 12 and 5 volts, or if you’re Dead Cat ran just out of 9 lives and needs a replacement.

The new lower board has direct solder pads for the motor ESC power lines right at the base of the arms and power “in” pads located directly above the battery to minimize cabling. There are power connector’s at the front, back and middle for your FPV gear and flight controller, all tied to the (optional) power shield which effortlessly supply’s a regulated, filtered and RF Noise shielded 5 volts at a whopping 3 amps for the camera and flight controller and 12 volts at 1 amp for the hungriest of video transmitters. The video connectors at the front and rear also not only supply the voltage but also the audio and video signal from the front mounted camera to the rear mounted video transmitter. This upgrade will save you weight, clean up your layout and improve reliability by reducing connection failures. I guess this Dead Cat has 9 lives after all!

* This is the defibrillator main board without the power shield, a kit is available with both.

Features:
• Integrated power distribution
• Wick style solder pads
• Camera and video transmitter integrated wiring
• 3 or 4 cell input
• SMPS converter with RF noise protection and thermal protected shield (optional)

Specs:
Input voltage: 8-16v (3-4 cell lipoly)
Weight: 128g W/O power shield, (142g with optional power shield)
Output: 5V/3A and 12V/1A (with optional power shield)

* Note the dead cat Defibrillator conversion for the SK450 requires the Sk450 frame and Dead Cat Conversion  and optional Power Shield related below.