Slow-Cure 30 Min Epoxy 9. oz
SLOW-CURE 30 min. epoxy works best for forming reinforcing fillets on joints. It has the highest strength of our epoxies. It is waterproof and more heat resistant. SLOW-CURE can be used for bonding if you are willing to wait overnight. Fillers such as microballoons can be mixed with SLOW-CURE and FINISH-CURE to form a putty-like consistency. Such fillers will usually decrease the working time by about 25%. Bonded objects can be handled after 8 hours and the cured epoxy reaches full strength within 24 hours.
Certified Buyer RatedSambuh
Quality Value OverallI use it for years and never had a problem.
Very good and strong glue.
Quality Value OverallCustomer RatedSndel Quality Value OverallAll good and pretty but if this is slow I'm a nun!
It is said on the label that mixing it in large quantities, the working time is greatly reduced!
By large quantities they must mean 10 grams or so!
I mixed a 40g (25 degrees in the air) batch and was left starring at most of it hardening in 3 (three) minutes or so.
This is not for laminating more than 100 square centimeters of composite cloth with a batch unless the reaction is seriously tempered.
I will try to mix it and laminate from a cooling bath of water and ice and pre-cool the resin in the fridge.
Quality Value OverallCustomer Ratedsymowallo Quality Value OverallExcellent quality epoxy which can be used for filling (with microballoons), gluing and laminating. Some people have questioned whether it's usable for laminating, and I have found that thinning it with just a small amount of spraying thinner makes it a little easier to spread into the glass fibres when laminating. I use Norglass Methyl Ethyl Ketone to thin it in this situation, but it would probably be OK to just heat it up before applying it for the same result.
It's a little tougher to sand than the 20 minute version, but I feel that this one is more versatile because of the extra strength and increased working time.
Quality Value Overall Quality Value Overallmalgrs les graduation sur la bouteille,un peu dur a doser mais tiens bien Quality Value OverallCertified Buyer RatedRonymahony Quality Value OverallSuper zum laminieren ec..
Ca auf 25 celsius erwrmen, so wird er flssiger zum laminieren verglasen. Doch achtung,je wrmer desto schneller hrtet er aus..
Quality Value Overall Quality Value OverallGreat glue I wo use it again Quality Value OverallCertified Buyer RatedDean Blair Quality Value OverallDoes the job! Cheaper to buy from hobbyking than it is local model ship! Thanks a lot HK!! Quality Value OverallCertified Buyer RatedBakerman Quality Value OverallSuper................ openingtime 30min let it cure. i let it cure over night. Quality Value OverallCertified Buyer Ratedgaastragtx Quality Value Overallexcellent quality. very durable and hardens after about 20 minutes Quality Value OverallCertified Buyer Ratedgaekay Quality Value OverallDe la colle toujours de la colle que se soit pour rparer ou monter un nouveau jouet. Il en faut. Trs bon maintient utilisation facile et que vouloir de plus ? Quality Value Overall
Use spaces to separate tags. Use single quotes (') for phrases.
Now save save $0.00 $0.00$2.16