The Storm 32 3 Axis BGC is a high quality DIY brushless gimbal controller that offers unparalleled professional stabilisation properties at 32Bit level. The Storm 32 board also features an integrated HC06 Blue tooth unit which allows you to program the board wirelessly without any cable connections.
The Storm 32 has a 32Bit microprocessor which operates at 72MHz and provides sufficient power to your DIY gimbal assembly. The 32Bit microprocessor and firmware combined provides an incredible range of programming functions.
The on board output options provide a multitude of connectivity options including PWM, PPM, IR LEDs, joystick, button, 7 x auxiliary ports which can be used as inputs and/or outputs for PWM/Sum-PPM signals. The Storm 32 also supports the connection of a range of satellite receivers including Futaba S-Bus and Spektrum types.
• Processor: STM32F103RC at 72Mhz
• Motor driver: DRV8313 with short circuit, overheat protection
• On board gyro and acceleration sensor MPU6050
• IR LED Interface
• Futaba S-BUS Compatible / Spektrum satellite port
• 7CH PWM/Sum-PPM input/output
Power Supply: 12v (3S)
Drive Current: Max 1.5A
Dimensions: 50 x 50mm
Mount Holes: M3
1 x Brushless controller
1 x Controller case
1 x MPU6050 sensor
1 x Sensor case
1 x Sensor connecting cable
1 x Pin set
the controller arrived without a bluetooth module and the cable wich connects the camera IMU and the main board is useless... the cable has one female connector, the other end is loose (tinned) cables. on the IMU board there are pads for a connector though no connector has been placed.. on the main board there are also pads though aswell here, the connector is missing.. and since i can not solder 0.5mm pads the camera IMU is a bit useless.."The Storm 32 board also features an integrated HC06 Blue tooth unit"
This board does NOT come with a bluetooth unit.
The protective cover comes with holes in the side for motor and pot. inputs but all the pins supplied are straight.