The TURNIGY 1:4 scale gokart is a real blast to drive, with it's low center of gravity and ultra sticky TruRubber* tyres which keep the kart turning sharply. A powerful full size servo is included with kart to keep the steering precise and quick, while the non differential rear tyres lay rubber on each corner!
The entire floor pan is made of 4mm Carbon fiber sheet with very little suspension travel at the rear giving the gokart very realistic handling.
You will need a 35A ESC, an inrunner motor around 3900Kv, a tansmitter and receiver and 2S LiPo battery.
Stickers are included, but the driver is unpainted so you can create your own race livery on the driver.
Width: (F)262mm / (R)305mm
Ground Clearance: 5~12mm
Top Speed: 45~60km/h
Tyres: 56×30mm / 58×45mm
Pinion: 13T (Required)
Gear Ratio: 13:2.37
Drive/Main Ratio: 13:47
T-Tube/Main Ratio: 20:30
Driving Weight: 2,100g (approx.)
35A Car ESC (TR35A-V2, 60A-SL or HK-45A)
Receiver/Transmitter (HK-GT2 or other 2~3 channel Tx)
LiPo: 2S 4000~5200mAh Hardcase Lipo (140x48x50mm max size)
13T Pinion gear.
TruRubber: TURNIGY's very own super-soft rubber compound that sticks to road surfaces better than standard street tyres.
Good quality.. Please use nut retainer on all screw except plastic.Ok, first just place your order for one and get all the stuff they offer for it like the bec and lipoly get a radio from em too, these karts are going to blow you away, I just got mine running and a small test drive with the stock motor and it jams,,, I got the upgraded motor but wont be using untill I get this thing under control, I have a gyro to use if needed, but if you looking for something to make your neighbors wake up get one. way coolI made some mods on this Go-Kart ...
and indeed i have troubles ...
i can't go straight forward any more
because i put a 3650 motor with
10500 KV !!!
The thing is like a rocket , when moving backwards . ( I will post some evidence ...)
One more thing to mention is that the steering servo saver
is a total failure as it broke without even an impact ...